Investigation Of Stress And Morphology In Electrodeposited Copper Nanofilms By Cantilever Beam Method And In Situ Electrochemical Atomic Force Microscopy

Both stress and atomic force microscopy (AFM) measurements were carried out in situ during potentiostatic electrodeposition of copper on gold in 0.05 mol dm(-3) CuSO4 in 0.1 mol dm(-3) H2SO4 with and without additives. With no additives, compressive stress generally developed initially and films subsequently underwent a compressive-to-tensile (C-T) transition. With increasing negative potential, the time for the C-T transition decreased rapidly as the rate of coalescence of nuclei (measured by AFM) increased rapidly. This is consistent with models that attribute the C-T transition to increasing tensile stress due to coalescence of nuclei. Furthermore, at a potential of -75 mV (Cu/Cu2+), where AFM showed very little coalescence of nuclei, no C-T transition was observed, again consistent with these models. The nucleation density measured by AFM increased from 2.7x10(7) cm(-2) at -75 mV to 2.5x10(9) cm(-2) at -300 mV. Stress measurements with a combination of three additives [1x10(-3) mol dm(-3) Cl-, 8.82x10(-5) mol dm(-3) polyethylene glycol, and 1x10(-5) mol dm(-3) 3-mercapto-1-propanesulfonic acid sodium salt (MPSA)] also showed that compressive stress generally developed initially and its magnitude was greater than in additive-free electrolyte. At less negative potentials, even though the rate of coalescence of nuclei was rapid, as observed by AFM, the stress continued to evolve in the compressive direction. At intermediate potentials (-90 to-150 mV), classical compressive-tensile-compressive (C-T-C) behavior was observed, while at more negative potentials the stress continued to evolve in the tensile direction. Similar results were obtained with a combination of two additives (1x10(-3) mol dm(-3) Cl- and 1x10(-5) mol dm(-3) MPSA), but in that case the compressive stress appeared to be greater, and consequently the T-C transition was observed even at -500 mV. The results are consistent with enhancement of a compressive component of stress in the presence of additives. (C) 2008 American Institute of Physics.