Effect of Ø 0.11 mm Z-pinning on the properties of composite laminates via an ultrasound guided insertion process

This paper develops an ultrasound guided Z-pinning process, which can insert finer Z-pins of Ø 0.11 mm (in comparison with traditional Ø 0.28 mm - 0.50 mm) with minimal in-plane damage and substantially improve the interlaminar performance of Z-pinned composite laminates. The experimental results show that for unidirectional fibre/epoxy laminates reinforced by 0.1 vol% of Ø 0.11 mm carbon Z-pins, the in-plane strength reduction is only 1.31% in tension and 3.46% in compression, respectively, while the Mode-I fracture toughness can be improved by 11 times in comparison with the unpinned specimens. The results can be attributed to the small damage to the microstructures of the pinned area, where long and narrow resin-rich zone with small in-plane fibre waviness and neglectable out of plane fibre crimp are represented. The interlaminar toughening mechanism of fine Z-pinned laminates is elucidated by the bridging law with the establishment the DCB testing model based on the traditional Z-pin reinforcement mechanism.