Designing 3D-Printed Mesh-Covered Fluid Collecting Racks (MFCRs) to Prevent Moisture-Related COVID-19 Sampling Interruptions in Taiwan

Background: A sampling platform (or table) set at the patient's side in a zero-exposure screening center (booth) might be used for specimen collection during public health crises such as the COVID-19 pandemic. However, repeated sanitization causes moisture problems. Such moisture problems would not only be noted by patients but also interrupt the sampling process. In this study, we aimed to develop 3D-printed mesh-covered fluid collecting racks (MFCRs) to address surface moisture problems to determine whether MFCRs can shorten the sampling time. Methods: This was an observational, descriptive, and cross-sectional study. We observed the reasons for sampling interruptions related to surface moisture problems among patients who used MFCRs or did not (April 28-30, 2022). We used a 3D printer to make an MFCR, which measured 14.5 cm in width and length and 1.0 cm in height. The MFCR allows the ethanol to drain through the mesh into the fluid collection rack below to leave a relatively dry surface on the mesh. Finally, we calculated the median time to finish sampling between MFCRs and non-MFCRs. Results: A total of 400 patients were randomly observed (using MFCRs, n = 200; non-MFCRs, n = 200). Patients in the non-MFCR group were more likely to interrupt the sampling process (n = 39, 19.5%) by noting surface moisture problems than those in the MFCR group (n = 3, 1.5%). Two of the major interruptions, "asking questions about the moist surface" (from 12% to 1%) and "slowing down their actions" (from 4.5% to 0.5%), were obviously improved by using MFCRs. Overall, the median sampling time was significantly shorter (p < 0.001) in the group using MFCRs (0.6 min) than in the group using non-MFCRs (1.5 min). The MFCRs shortened the sampling time by 60%, which might be associated with decreasing interruptions caused by surface moisture problems. Conclusions: The 3D printed MFCRs are suitable for handling surface moisture problems caused by repeated sanitizations. More importantly, the MFCRs might be associated with decreasing interruptions caused by moisture problems.