Synthesis and characterization of stereolithography 3D printing fluorescent resin

Abstract In this study, bisphenol A epoxy resin, 1,6‐Hexanediol diacrylate (HDDA), and 2,4,6‐Trimethylbenzoyl‐diphenylphosphine oxide (TPO) were utilized as a prepolymer, diluent, and photoinitiator, respectively, to prepare a light curing system with different amount of phosphor, which was used in place of conventional inorganic fillers. Phosphor was utilized to improve the precision of the material molded parts during the light curing process and enhance the mechanical properties of the molded parts owing to the ultraviolet (UV) absorption properties of phosphor, which prevented UV damage to the material, thus improving the light aging resistance and stability of the molded parts. Results revealed that the addition of 3% phosphor optimized the mechanical properties of the material (a maximum tensile strength of 42.43 MPa). Additionally, the material achieved the lowest linear (4.1%) and volumetric (0.58%) shrinkage at a phosphor content of 6%. This study provides a new insight into three‐dimensional (3D) printing resin for stereolithography and provides a reference for the improvement of 3D printing products.