Seismic behavior of an improved drilled flange connection for I-beam to CFST column

The use of cold-formed steel tubes in the concrete-filled steel tubular (CFST) columns makes the design of the moment connections between beams and CFST columns much more challenging. This is because setting the internal diaphragms in the CFST column to transfer the bending moment of the beam end becomes impossible, and thus new joints are needed. A novel joint was proposed in a previous study by the authors, where two end plates were used for the force transmission between CFST columns and beam flanges. Moreover, to satisfy the “weak member strong joint” requirement, the I-beams were reduced by drilling a series of circular holes in their flanges. However, most of the tested specimens failed by the unexpected rupture of the complete joint penetration (CJP) groove welds between the beam flanges and end plates. In this paper, three specimens are redesigned and tested, where modifications are made to improve their behaviors under the seismic load. In this test, the local buckling of beam flanges at the drilled sections was observed in all specimens, and two specimens failed due to the fracture at the drilled sections, while CJP weld fracture and significant bending of beam flanges both occurred at the failure of the rest specimen. The hysteresis curves of all specimens are fusiform, indicating their good energy dissipations (the maximum equivalent viscous damping coefficients between 0.35 and 0.40). The failure rotation angles are about 2.44–3.01, and the ductility coefficients are between 2.26 and 2.66. According to EC3, all specimens can be classified into the rigid and full-strength joints. Subsequently, the parametric analyses using the validated finite element model are carried out, where the effects of main parameters are investigated on the seismic behavior of the presented joint. This study brings insights into the moment connections between the steel beam and CFST column with the outer cold-formed section.