On the VOC Loss in NiO-based Inverted Metal Halide Perovskite Solar Cells

On the VOC Loss in NiO-based Inverted Metal Halide Perovskite Solar CellsKousumi Mukherjee a, Denise Kreugel a, Nga Phung a, Cristian van Helvoirt a, Valerio Zardetto b, Mariadriana Creatore a, ca Department of Applied Physics, Eindhoven University of Technology, partner in Solliance, P.O. Box 513, 5600 MB Eindhoven, The Netherlandsb TNO, partner in Solliance, High Tech Campus 21, 5656 AE Eindhoven, The Netherlandsc Eindhoven Institute of Renewable Energy Systems (EIRES), PO Box 513, 5600 MB Eindhoven, The NetherlandsInternational Conference on Hybrid and Organic PhotovoltaicsProceedings of International Conference on Hybrid and Organic Photovoltaics (HOPV24)València, Spain, 2024 May 12th - 15thOrganizer: Bruno EhrlerOral, Kousumi Mukherjee, presentation 054DOI: https://doi.org/10.29363/nanoge.hopv.2024.054Publication date: 6th February 2024A perovskite p-i-n architecture PV device generally adopts solution-processed organic hole transport layers (HTLs), like PTAA or self-assembled monolayers (SAMs). However, this approach can result in an inhomogeneous HTL surface coverage, especially when processed on textured substrates [1-2]. Recent reports have shown that the adoption of atomic layer deposited (ALD) nickel oxide (NiO) in combination with organic layers, such as PTAA or SAM, addresses the above-mentioned issue and leads to higher device yield, for both single junction [3] as well as tandem (in combination with c-Si or CIGS) devices [1-2]. Nevertheless, implementing NiO in devices without PTAA or SAM is seldom reported to lead to highly performing devices. In the present contribution, we systematically assess the effect of key properties of NiO deemed relevant in literature, namely- resistivity and surface energy, on the device performance and compare the ALD NiO-based devices to those based on PTAA. To this purpose, (thermal) atomic layer deposited (ALD) NiO, Al-doped NiO, and plasma-assisted ALD (PA-ALD) NiO films are investigated as HTLs in a single junction mid-bandgap perovskite solar cell. The resistivity of Al-doped NiO and PA-ALD NiO films are 400 Ω∙cm and 80 Ω∙cm respectively and they are lower than that of thermal ALD NiO (10 kΩ∙cm). However, the devices implementing Al-doped and PA-ALD NiO HTLs exhibit only a modest VOC gain of ~30 mV compared to thermal ALD NiO-based devices. Overall, the best-performing NiO-based devices (~14.8% PCE) still lag behind the PTAA-based devices (~17.5%) primarily due to a VOC loss of ~100 mV. Moreover, we observe that the average grain size and the overall crystal quality of the perovskite absorber, which can impact the VOC, is not affected by the surface energy of the different NiO HTLs. Further investigation based on the light intensity analysis of the VOC and FF and the decrease in VOC compared to the quasi-Fermi level splitting (QFLS), indicate that the VOC is limited by trap-assisted recombination at the NiO/ perovskite interface and that a better charge extraction occurs when PTAA is adopted. Additionally, SCAPS simulations show that the VOC of the NiO-based devices decreases when trap states are present at the NiO/ perovskite interface. Whilst tuning the resistivity of NiO has a negligible impact on the device performance, we also show that passivating the NiO/ perovskite interface with Me-4PACz SAM recovers this VOC loss with an increase of ~200 mV. Our study shows that the potential positive effect of decreasing NiO bulk resistivity on the device performance is shadowed by the high recombination at the NiO/perovskite interface. Lastly, our work highlights the necessity of comparing devices based on emerging transport layers, such as NiO, with state-of-the-art transport layers-based devices, which is often neglected in the literature, in order to draw conclusion about the influence of specific material properties on the device performance. References:[1] Phung, N.; Zhang, D.; van Helvoirt, C.; Verhage, M.; Verheijen, M.; Zardetto, V.; Bens, F.; Weijtens, C. H. L.; Geerligs, L. J. (Bart); Kessels, W. M. M.; Macco, B.; Creatore, M. Atomic Layer Deposition of NiO Applied in a Monolithic Perovskite/PERC Tandem Cell. Solar Energy Materials and Solar Cells 2023, 261, 112498[2] Jošt, M.; Bertram, T.; Koushik, D.; Marquez, J. A.; Verheijen, M. A.; Heinemann, M. D.; Köhnen, E.; Al-Ashouri, A.; Braunger, S.; Lang, F.; Rech, B.; Unold, T.; Creatore, M.; Lauermann, I.; Kaufmann, C. A.; Schlatmann, R.; Albrecht, S. 21.6%-Efficient Monolithic Perovskite/Cu(In,Ga)Se 2 Tandem Solar Cells with Thin Conformal Hole Transport Layers for Integration on Rough Bottom Cell Surfaces. ACS Energy Lett. 2019, 4 (2), 583–590.[3] Phung, N.; Verheijen, M.; Todinova, A.; Datta, K.; Verhage, M.; Al-Ashouri, A.; Köbler, H.; Li, X.; Abate, A.; Albrecht, S.; Creatore, M. Enhanced Self-Assembled Monolayer Surface Coverage by ALD NiO in p-i-n Perovskite Solar Cells. ACS Appl. Mater. Interfaces 2022, 14 (1), 2166–2176.Acknowledgements:This work is carried out under the "New Energy and Mobility Outlook for the Netherlands" (NEON) project with project number 17628 of the research programme NWO Crossover which is (partly) financed by the Dutch Research Council (NWO). The authors would like to thank Dr. Christ H.L. Weijtens for carrying out the UPS measurements, Wim Arnold Bik (from Detect 99) for carrying out the RBS measurement and Caspar O. van Bommel, Joris J. I. M. Meulendijks, and Janneke J. A. Zeebregts for their technical support. K.M. acknowledges Wouter Vereijssen for his contribution in the surface energy studies. K.M. thanks Dr. Sinclair Ryley Ratnasingham for his insightful comments and help in the SCAPS simulation. M.C. acknowledges the NWO Aspasia program. V.Z. acknowledges Research and Cooperation Fund from Ministry of Economic Affairs and Climate Policy. © FUNDACIO DE LA COMUNITAT VALENCIANA SCITOnanoGe is a prestigious brand of successful science conferences that are developed along the year in different areas of the world since 2009. Our worldwide conferences cover cutting-edge materials topics like perovskite solar cells, photovoltaics, optoelectronics, solar fuel conversion, surface science, catalysis and two-dimensional materials, among many others.MATSUSPreviously nanoGe Spring Meeting (NSM) and nanoGe Fall Meeting (NFM), MATSUS is a multiple symposia conference focused on a broad set of topics of advanced materials preparation, their fundamental properties, and their applications, in fields such as renewable energy, photovoltaics, lighting, semiconductor quantum dots, 2-D materials synthesis, charge carriers dynamics, microscopy and spectroscopy semiconductors fundamentals, etc.International Conference on Hybrid and Organic PhotovoltaicsInternational Conference on Hybrid and Organic Photovoltaics (HOPV) is celebrated yearly in May. The main topics are the development, function and modeling of materials and devices for hybrid and organic solar cells. The field is now dominated by perovskite solar cells but also other hybrid technologies, as organic solar cells, quantum dot solar cells, and dye-sensitized solar cells and their integration into devices for photoelectrochemical solar fuel production.Asia-Pacific International Conference on Perovskite, Organic Photovoltaics and OptoelectronicsThe main topics of the Asia-Pacific International Conference on Perovskite, Organic Photovoltaics and Optoelectronics (IPEROP) are discussed every year in Asia-Pacific for gathering the recent advances in the fields of material preparation, modeling and fabrication of perovskite and hybrid and organic materials. Photovoltaic devices are analyzed from fundamental physics and materials properties to a broad set of applications. The conference also covers the developments of perovskite optoelectronics, including light-emitting diodes, lasers, optical devices, nanophotonics, nonlinear optical properties, colloidal nanostructures, photophysics and light-matter coupling.International Conference on Perovskite Thin Film Photovoltaics Perovskite Photonics and OptoelectronicsThe International Conference on Perovskite Thin Film Photovoltaics Perovskite Photonics and Optoelectronics (NIPHO) is the best place to hear the latest developments in perovskite solar cells as well as on recent advances in the fields of perovskite light-emitting diodes, lasers, optical devices, nanophotonics, nonlinear optical properties, colloidal nanostructures, photophysics and light-matter coupling.