The effect of filler grain size, quartz content in the filler and firing conditions (sintering temperature, firing time) on the physical and mechanical properties of a sanitary-ware porcelain has been studied in the narrow range of values used by industrial practice. The investigation has been carried out using the Taguchi method for experimental design. Quartz grain size is the most important factor regarding the physical properties and dominates bending strength in two ways, directly by inducing compressive stresses to the vitreous phase and indirectly through the development of a favorable microstructure. The characteristics of the last are discussed in detail. The optimum grain size of quartz was found to be 5–20 μm. This results in 20–30% increase of bending strength compared to the reference porcelain. The results confirm the “Matrix Reinforcement” theory, however, the positive effect of mullite content on bending strength was not observed.
Rotatable magnetron sputter sources are standard equipment in large scale sputter industry for the deposition of metals and metal oxides. The power input in a rotatable magnetron can be much higher compared to a planar magnetron, resulting in improved discharge characteristics and increased deposition speed. In order to develop rotatable magnetron deposition of YBa2Cu3O7−x (YBCO) on an industrial scale, the construction of large cylindrical YBCO targets using plasma and flame spraying was explored. Large cylindrical targets (∅ 13cm×30cm length) consisting of a stainless steel substrate coated with a 5 mm YBCO coating were fabricated. This paper describes the microstructure, mechanical, structural, thermal and electrical characterisation of the obtained coatings and the characteristics of the targets during magnetron sputtering.
The adhesion of γ-alumina washcoats on cordierite honeycombs was investigated with the aim to correlate the adhesion properties to the characteristics of the deposited powders, and, determine the conditions that can ensure integrity and endurance of the substrate/washcoat system under the severe operating conditions of an automobile catalytic system. It is shown that adhesion depends primarily on the particle size of the deposited powder. Depending on the production method, some powders have the form of large agglomerates and, if deposited as such upon the honeycombs, exhibit very poor adhesion properties. Reduction of the agglomerates' size down to the order of a few (2–5) microns is necessary in order to ensure adhesion comparable to that of commercial catalysts. Particles of colloidal dimensions exhibit excellent adhesion to the support, provided that reduction of the agglomerates' size that they form during calcination, takes place before deposition.