
Spaceflight-induced bone loss may increase the risk of fracture during long-duration missions. Exposure to artificial gravity (AG) of 1 G by centrifugation has been shown to prevent spaceflight-associated bone loss in mice. However, whether lower levels of AG can prevent skeletal deterioration during spaceflight is unknown. Young adult (11 weeks) male C57Bl/6 J mice were exposed to microgravity (µG) or AG (0.33 G, 0.67 G, or 1 G) via centrifugation during a 30-day mission on the International Space Station (n = 5-6/group). Ground controls were housed in an identical habitat (HGC, n = 12). We used DXA to measure body composition and bone mineral density (BMD) pre- and post-flight in vivo. After necropsy, we measured bone microarchitecture, histomorphometric parameters, and gene expression. Spaceflight led to a marked increase in total body fat mass, which was prevented by AG in a dose-dependent fashion. Mice exposed to 1 G of AG had equivalent bone mass, microarchitecture, and strength compared to HGC, but lower levels of AG only partially mitigated these bone deficits. AG prevented deficits in endocortical bone formation, but only partially preserved periosteal bone formation. Cortical bone transcriptomic patterns were altered in µG and returned to those of HGC with increasing levels of AG. Exposure to levels of AG below 1 G during spaceflight partially mitigates spaceflight-associated bone deficits, though not consistently in a dose-associated manner. 1 G of artificial gravity was necessary to ameliorate most of the microgravity-associated deficits in bone health.
Extrusion-based bioprinting is a promising technology for in-space biofabrication, yet peer-reviewed process data derived in real microgravity remain rare. In the presented study, we used parabolic flights as a platform to characterize extrusion-based bioprinting of an alginate-methylcellulose bioink in short-term microgravity. Layer-by-layer printing was performed successfully at different layer distances (260–610 µm), and unsupported filament bridges of up to 13 cm were successfully printed under microgravity. We performed what is, to our knowledge, the first “green” bioprinting of microalgae-laden hydrogels under microgravity, with the cell viability of the thereby created samples exceeding 99% for Scenedesmus sp. and reaching 97% for Chlorella vulgaris on day 7 post-printing. Real-time pulse-amplitude modulated (PAM) fluorometry showed that the effective quantum yield of photosystem II remained stable across all gravitational phases in both liquid cultures and bioprinted samples while maintaining species-specific differences in non-photochemical quenching between the two species. The results of the study indicate that extrusion-based green bioprinting is functionally achievable under short-term microgravity conditions and that cultivation of the thereby created photosynthetically active structures is possible without loss of photosynthetic performance.
Evaporation-driven droplet deposition is central to printing and coating technologies, where capillary, Marangoni and buoyancy-driven flows govern particle organization and surface functionality. While buoyancy significantly affects internal convection under terrestrial conditions, its impact on the morphology and wettability of nanostructured coatings remains unclear. Here, we investigate gravity-dependent evaporation-assisted deposition of carbon nanomaterials using microgravity experiments performed within the ARLES campaign aboard the MASER 14 rocket, supported by the European Space Agency. Sessile droplets of HFE-7100 containing carbon nanotubes (CNTs), graphene flakes, or a 50/50 CNT–graphene mixture were sequentially deposited on silicon substrates under microgravity and reference 1 g conditions. Coatings obtained after up to four depositions were characterized by scanning electron microscopy and static water contact angle measurements. Microgravity markedly altered particle organization and pore structure. CNT coatings formed denser packings with smaller pores, resulting in increased hydrophobicity compared to 1 g samples. In contrast, graphene coatings exhibited greater roughness under microgravity and reduced contact angles. Mixed coatings showed gravity-dependent phase organization, yielding intermediate wettability in microgravity and graphene-dominated behavior at 1 g. These findings demonstrate that buoyancy-driven flow during evaporation controls nanoscale assembly and macroscopic wettability, highlighting microgravity as a platform for tailoring functional nanostructured coatings.
Maintaining adequate nutritional intake and body mass is critical in spaceflight and its terrestrial analogs; however, comprehensive evidence on dietary intake patterns and nutritional adaptations during long-term isolation and confinement remains limited. Following PRISMA guidelines, this systematic review synthesizes evidence on dietary intake and nutrition-related adaptations in isolated and confined environments. Across 184 studies, dietary structure ranged from highly standardized to highly variable. Energy intake differed substantially across habitats, whereas macronutrient distributions remained within recommended ranges, characterized by stable protein intake across habitats and more variable carbohydrate and fat contributions. Body mass generally decreased, with the greatest heterogeneity observed in terrestrial isolated, confined, and extreme environments. Vitamin D insufficiency was consistently reported but could be effectively prevented through supplementation. Overall, isolated and confined environments challenge nutritionally adequate food systems, and current evidence is insufficient to draw firm conclusions on optimal strategies, particularly for longer-duration space missions.
Recent developments in commercial suborbital spaceflight have expanded opportunities for researchers to fly with their experiments. In an accompanying paper in npj Microgravity, we report results from a researcher-tended experiment aboard Blue Origin New Shepard flight NS-261. This Perspective examines the historically rare role of scientists flying to conduct their own research and argues that firsthand participation in spaceflight enriches scientific observation, interpretation, and discovery.