
Slip instabilities leading to earthquakes, landslides, and glacier surges may be triggered by high fluid pressures at the slipping interface. High fluid pressures may, however, also suppress instability because of large nucleation length-scales in overpressured systems. We review geological, glaciological, and rock mechanical observations and highlight two key scales that control fluid pressure-enabled frictional instabilities: (1) the length scale over which fluid overpressure is maintained, and (2) a time scale defined by relative rates of deformation propagation and fluid transport. These scales are also dependent on rheological regime, and we suggest three end-member regimes: (1) brittle-localising (BL) regimes where deformation and fluid flow localise to discrete interconnected structures; (2) brittle-delocalising (BD) regimes where deformation and fluid flow are distributed over a broad region, and instability typically stabilised by fluid diffusion; and (3) transiently brittle (TB) regimes where in dominantly viscous rock or ice, fluid pressure may induce a transient frictional rheology that is typically delocalised and stabilised by dilatant hardening. In the BL regime, fluid overpressure can be sustained over a sufficient length scale to enable the nucleation and propagation of frictional instabilities. In the BD and TB regimes, however, fluid-driven instabilities tend to be suppressed, confined to local areas of overpressure, or rate-limited by fluid diffusion, because deformation delocalises in the bulk and/or dilatant hardening limits slip propagation. The three regimes can also be applied to glaciers, where viscous flow of ice competes with frictional sliding on the glacier base—here, sustained and interconnected high water pressure at the glacier base is commonly invoked as promoting frictional instability. In both rock and ice, these concepts imply that fluid-driven frictional instabilities are limited to areas where fluid overpressured patches can be interconnected, and therefore highlight the key role of fluid pressure heterogeneity in development of slip instabilities.
The Salton Trough, located along the border between southern California and northern Baja California, comprises a series of complex basins and faults associated with the oblique rift margin of the Gulf of California. However, the subsurface structural linkage between the Mexicali Valley and the Altar Basin remains poorly constrained. Analogue and numerical models of oblique rifts commonly predict the development of two depocenters separated by a cross-basin fault. Here we analyze 2D seismic profiles from the border region between these basins and identify such a structure. Our interpretation reveals the Riíto Basin, which displays an asymmetrical geometry indicative of significant dip-slip displacement on the Cerro Prieto Fault, and the Lagunitas Basin, which was previously considered part of the Altar Basin but is here reinterpreted as a distinct depocenter. Together, these basins constitute a dual-depocenter model crossed by a cross-basin fault, the West Calipatria Fault. We propose that this fault links two major displacement zones: to the north, the Calipatria Deformation Zone, recently interpreted as an ancient, now-inactive plate boundary; and to the south, the Cerro Prieto Fault, which forms part of the present-day plate boundary. These structures are typical of divergent oblique rifting and are consistent with the regional tectonics of the Salton Trough, providing valuable insights into the geometry and kinematics of active faults in the subsurface of this transtensional pull-apart basin.
The eastern margin of the Peninsular Indian Shield comprises four distinct crustal provinces: the Chhotanagpur Gneissic Complex, the Singhbhum Mobile Belt, the Singhbhum Craton, and the Eastern Ghats Mobile Belt. These provinces collectively record a complex history of Proterozoic crustal evolution. In this study, we integrate 12,650 land-based gravity points with independently constrained P-wave receiver functions to construct a series of 21/2D density models extending to Moho depths along similar to 650 km long NW-SE transects. These models offer deep insights into lateral variations in crustal thickness and density structure, as well as their tectono-magmatic implications for the Eastern Indian Shield. The Moho beneath the Eastern Ghats Mobile Belt exhibits a systematic deepening, ranging from similar to 35 km near the present-day coastline to similar to 38 km toward the Kerajang Fault and the Sukinda Thrust Belt. Beneath the Mahanadi Basin, the presence of a high-density (3.02 g/cm(3)) layer in the lowermost crust is interpreted as magmatic underplating, a possible explanation for a dense lower-crustal body. Crustal thickness beneath the southern part of the Singhbhum Craton reaches similar to 41 km and gradually thins northward to similar to 36 km. The preferred geometry of the Singhbhum Mobile Belt is a northward-dipping crustal block associated with a Moho depth of similar to 40 km. Similar Moho depths are observed beneath the Chhotanagpur Gneissic Complex (39-41 km), with further deepening beneath the adjoining foreland Ganga Basin, to a maximum of similar to 43 km. The two mobile belts are marked by higher crustal densities relative to the adjacent cratonic domains and are bounded by model-consistent crustal-scale discontinuities. The pronounced lateral variations in crustal thickness and density, inferred from integrated gravity modelling, reflect episodic thermotectonic processes associated with Proterozoic crustal growth and reworking along the eastern segment of the Indian Shield.