
The present study was undertaken to investigate changes in the solidification microstructure consisting of Zn(hcp), alpha-Al(fcc), and Zn2Mg phases in the hot- dip Zn- 6Al-3Mg (mass%) alloy coating during isothermal holding at an elevated temperature of 200 degrees C (below the solidus temperature), in terms of the transformation from Zn2Mg metastable phase to Zn11Mg2 stable phase. The macroscopic Vickers hardness increased approximately from 150 HV to 180 HV after holding at 200 degrees C for 36 ks. The hardness change corresponded well with the occurrence of the Zn2Mg -> Zn11Mg2 phase transformation identified by X-ray diffraction analyses. The Zn11Mg2 stable phase nucleated at the interface between Zn2Mg and Zn(hcp) phases, and grew by consuming both phases formed in the initial solidification microstructure. Nanoindentation measurements revealed that the Zn11Mg2 p hase h ad a lower h ardness than the Zn2Mg phase. Therefore, the significant growth of the Zn11Mg2 phase, which consumes a large part of the soft Zn(hcp) phase, could contribute to the observed hardening of the hot-dip Zn-Al-Mg alloy coating during isothermal holding.
The liquidus and solidus temperatures of the Fe-Ni system were determined by differential scanning calorimeter. In addition, thermodynamic reassessment of the phase diagrams and thermodynamic properties of Fe-Ni, Fe-C, and Ni-C systems was performed based on literature data and present results. The Gibbs energy of the liquid phase of Fe-C and Ni-C systems was approximated using the association model. The Gibbs energies of the Fcc and Bcc phases were approximated using a two-sublattice model of the (Fe,Ni)(1)(C,Va)(0.25) structure. The calculation results were able to reproduce various experimental data. Furthermore, two-phase separation of the Bcc phase in Fe-C and Ni-C at low temperatures were predicted, and this trend is consistent with experimental data. On the other hand, the unreasonable two-liquid separation and the stabilization of the Bcc phase at high temperatures calculated in previous studies were not calculated. The phase diagrams of the Fe-Ni-C ternary system were also calculated using the parameters of the binary system obtained in this study. All experimental data could be reproduced without introducing ternary parameters. Thus, the model used in this study is suitable for development of a multicomponent database.