
The increasing environmental and health concerns associated with conventional chemical coagulants have stimulated the search for natural, biodegradable, and renewable alternatives for water and waste-water treatment. This study investigated different cultivars of common bean (Phaseolus vulgaris) as potential sources of natural coagulants and evaluated the effects of cultivar, harvest year, extraction solvent, pH, and raw material origin on coagulation activity. Natural coagulants were obtained from 12 common bean cultivars by ultrasound-assisted extraction using distilled water and 0.5 mol/L NaCl. In addition, the feasibility of utilizing harvest and sorting residues of the Sremac cultivar as a source of natural coagulants was evaluated. Coagulation performance was assessed by jar tests using kaolin-based model water with an initial turbidity of 200 NTU at pH 6, 8, and 10. All investigated cultivars exhibited coagulation activity, although substantial differences were observed among the extracts. The highest activities were obtained from the Balkan, Gradistanac, and Maksa cultivars, with maximum coagulation activities of 95.4% ± 0.08%, 94.5% ± 0.22%, and 90.1% ± 0.08%, respectively. In general, pH 6 was the most favorable condition for coagulation, while extracts prepared using 0.5 mol/L NaCl frequently exhibited higher activities than those obtained using distilled water. The harvest year also affected coagulation performance, particularly for the Levac cultivar. Extracts obtained from bean sorting residues showed lower coagulation activities than those prepared from the corresponding cultivar, although their use may provide a means of valorizing an otherwise low-value waste material. Overall, the results demonstrate that common bean, particularly the Gradistanac, Balkan, and Maksa cultivars, represents a promising and readily available source of natural coagulants for water and wastewater treatment.
This study aimed to investigate the influence of hot trub (HT) drying methods on the content of bio-active compounds (total phenols and flavonoids). The research evaluated the effects of various drying methods - conventional drying (50, 65, and 80°C), vacuum drying (50, 65, and 80°C at -0.95 bar), and lyophilization (-40°C at 0.128 mbar) - on the total phenolic and flavonoid contents, as well as the anti-oxidant activity (DPPH assay), of HT extracts. The results indicated that the applied drying method and temperature influenced the retention of target bioactive compounds and antioxidant capacity. Although freeze-drying preserved the highest content of flavonoids and overall antioxidant capacity, vacuum drying at moderate temperatures (50 - 65 °C) represents the most viable industrial approach, offering a superior balance between shorter drying duration, reduced operational demands, and high retention of bioactive polyphenols. These findings, based on a single processing batch, should be confirmed through further studies incorporating independent drying replicates.
Feta cheese is a popular white-brined cheese traditionally made with sheep's or cow’s milk. With growing interest in plant-based diets, coconut oil-based analogues have emerged as alternatives that aim to replicate the characteristics of dairy-based Feta cheese. However, the extent to which these analogues achieve the nutritional and sensory properties of traditional Feta remains inadequately studied. This study aims to compare the physico-chemical, textural, color, and sensory properties of Feta cheese made with cow’s milk with those of coconut oil-based analogues. Physico-chemical ana-lysis revealed that the analogues contained significantly higher fat content (up to 27.25%), but much lower protein (up to 1.450%) and ash content (up to 1.51%) compared to the cow’s milk Feta, which contained up to 13.4% protein and 3.44% ash. The pH values were also lower in the analogues (3.15 - 3.57) than in the dairy-based cheeses (up to 4.48), indicating reduced buffering capacity. Textural analysis indicated that the analogues were firmer, whereas the cow’s milk Feta samples were softer and more cohesive. Color measurements confirmed that both varieties had high lightness, but the analogues exhibited greater variations in tone and chroma, likely due to the presence of coconut oil. In the sensory evaluation, the Feta samples made with cow’s milk were preferred, characterized by a pleasant salty taste, a firm but crumbly texture, and a milky aroma. In contrast, the analogues were perceived as sour, less salty and pasty, resulting in a lower overall acceptance. Although coconut oil-based analogues resemble traditional Feta in appearance and hardness, they lack comparable nutritional value and sensory quality, indicating a need for formulation improvement.
This paper presents and analyses experimental data related to hydrodynamic characteristics and mass transfer performance in extraction columns with perforated (sieve) plates, based on results obtained from literature sources. The hydrodynamic characteristics of columns with sieve-plates were flooding speed, dispersed phase hold-up, mean diameter and size distribution of drop diameters, as well as phenomena present during the formation of drops at the opening of the sieve-plate. Experimental determinations were made in cases of presence or absence of mass transfer between the phases. Empirical correlations for the content of the dispersed phase, the mean diameter of the drops in the regime where there is no drop formation, and the height of the coalescence zone are also described in this paper. The characteristics of mass transfer during the formation of dispersed phase drops, as well as the growth and coalescence of drops, were discussed based on literature data. The separation efficiency was determined using the Murphree model. The empirical correlations were used to predict the extraction efficiency, and they showed a good agreement with the experimental results.
The study determined the volatile content of Malva sylvestris (MSEO), and evaluated the antioxi-dant, photoprotective, and anti-inflammatory activities, and cytotoxicity of its hydro ethanol extract (MSME) through various methods, with total bioactive content quantified spectrophotometrically. The dermatoprotective effects were assessed via sun protection factor (SPF) assays. The anti-inflamma-tory activity of MSME was tested in Wistar albino rats using a formalin-induced paw edema model and a protein denaturation model. Acute toxicity was evaluated by administering MSME at doses of 125, 250, 500, 1000, and 2000 mg/kg, focusing on liver and kidney histology, body weight, bioche-mical markers, and intoxication signs. Results indicated that MSME had a total flavonoid content of 20.00 ± 4.45 μg QE/mg and total phenolic content of 61.99 ± 0.08 μg GAE/mg. The β-carotene bleaching assay showed MSEO achieved 87.89 ± 1.68% effectiveness in antioxidant capacity. MSME exhibited strong radical scavenging ability for DPPH and ABTS, alongside significant dermatopro-tective and anti-inflammatory activity, with an IC50 value of 2.28 mg/mL in the protein denaturation model. In vivo studies demonstrated that oral administration of MSME at 200 and 400 mg/kg signi-ficantly reduced inflammation levels six hours post-edema induction. Acute toxicity results showed no significant body weight or biochemical marker effects at doses of 2000 mg/kg or lower, with normal liver and kidney histology. Key volatile compounds in MSEO included neophytadiene (17.3%), penta-cosane (16.24%), phytol (15.99%), hexahydrofarnesyl acetone (10.20%), 2-methyltetracosane (8.82%), and tetracontane (5.76%). Overall, the findings suggest Malva sylvestris as a promising natural source of bioactive compounds with significant antioxidant properties, highlighting potential applications in food, pharmaceuticals, and medicine. Further investigations are recommended to explore specific chemicals, molecular mechanisms, and additional in vivo tests for a better under-standing of its biological functions.