
The equivalence of two mixed type functional equations in Banach space is given.By using the fixed point method,the stability of the mixed functional equation in Banach space is built up step by step.Furthermore,the better upper bound is gotten.
In order to solve the problem of huge amount of brick-concrete waste construction waste polluting the environment and wasting resources in the process of urbanization in China,the natural aggregate was replaced by mechanical recycled brick-concrete aggregate,which aimed to analyze the feasibility of brick-concrete recycled aggregate as recycled concrete aggregate through experiments,and study the influence of brick-concrete recycled aggregate with different replacement mass fractions on the compressive strength of recycled concrete.The results showed that the reduction rate of compressive strength of concrete cube added with brick-concrete recycled aggregate increased with the increase of the replacement rate of recycled aggregate.When the replacement rate of recycled brick aggregate was within 10%,it had basically no effect on the strength,and when the proportion of brick-concrete aggregate exceeded 25%,the strength of brick-concrete aggregate recycled concrete began to decay significantly.
Based on the simulated acidification of sulfur addition in meadow steppe,the response of trace elements in plant leaves and roots to sulfur addition was studied.The results showed that compared with weeds,the leaves of grass had higher mass fraction of Fe and Mn and lower mass fraction of Ca and Mg;the responses of Ca and Mg in leaves of the four species to sulfur addition were relatively weak,and Mn increased significantly with sulfur addition(the variation range was 6%~72%),while the Fe mass fraction in weeds leaves decreased significantly(the variation range was 5%~5 2%);from the perspective of plant community level,with the increase of sulfur addition,the Ca mass fraction in roots decreased significantly,decreased by 18%at high sulfur level,and the Fe mass fraction in leaves and Mn mass fraction in leaves and roots increased significantly,increasing by 103%,93%and 106%,respectively;the variation of plant nutrients under sulfur addition was significantly affected by soil acidification indexes such as soil pH and exchangeable Al.
By adjusting the grating valve angle,studies on the structure and mechanical properties of TiN films deposited by arc ion plating were performed.The experimental results showed that the grating valve angle had no significant effect on the preferred orientation of TiN film,the films showed TiN(200)preferred orientation.With the increase of grating angle valve,N and Ti atomic percent content ratio in TiN films were substoichiometric,and first increased and then decreased,the highest N and Ti atomic percent content ratio was obtained at the grating valve angle of 10°.Surface roughness Ra of TiN thin films showed an increasing trend with the grating valve angle.The highest hardness value and the low wear rate were obtained at the grating valve angle of 10°,which presented the optimal mechanical and wear-resistant properties of TiN films.During film vacuum deposition by arc ion plating,the grating valve angle would affect film performance by influencing gas flow,but it had no significant effect on TiN film structure.By choosing the appropriate grating valve angle,the optimized performance of the thin films would be obtained.
In order to effectively intervene unsafe behaviors of workers in construction sites,considering the impact of unsafe behavior propagation,an influencing factor analysis model based on HFACS and SD was established.The HFACS-C applicable to the construction site was established by combining literature and accident reports;the HFACS-C was quantized,the SD model and SD equation were established,and a real project for analogue simulation was selected.The experimental results showed that the model could reflect the cumulative impact of unsafe behaviors,and provide help for managers to control and intervene.