
Lunar laser ranging represents the forefront of laser ranging technology.The considerable distance to the Moon and strong background light mean that the signal-to-noise ratio of lunar laser ranging signals is much lower compared with that of satellite laser ranging signals in Earth's orbit.Accurate processing of lunar laser ranging data is essential for its scientific applications.This paper addresses the challenge of the low signal-to-noise ratio in lunar laser ranging signals by developing a detection model based on computer vision techniques.The model was tested using both simulated data with a signal-to-noise ratio as low as-19 dB and measured data as low as-12.9 dB,with the results demonstrating that the model provides reliable detection in both cases,offering a robust approach for the effective processing of lunar laser ranging data.
Synthetic aperture radar(SAR)is an active microwave imaging sensor that enables day-and-night,all-weather Earth observation.When integrated on unmanned aerial vehicles(UAVs),SAR provides high-resolution imaging with small size,low cost,and high maneuverability,while shortening deployment and data turnaround.Focusing on large astronomical facilities,this paper presents the design and validation of a Ka-band UAV-borne phased-array SAR system.The payload adopts a modular,lightweight architecture compatible with multirotor,fixed-wing,and compound-wing airframes.The short wavelength of Ka-band millimeter-wave signals enhances sensitivity to fine linear features and complex metallic structures,making it well suited for precise geometric mapping,array-layout calibration,structural health monitoring,and perimeter inspection of astronomical facilities.We conducted multiple day-and-night flight experiments at the Mingantu Observing Station and acquired high-resolution two-dimensional SAR images of the Chinese Meridian Project Phase II interplanetary scintillation phased-array telescope and surrounding infrastructure.Results exhibit generally well-focused impulse responses with clear mainlobes and controlled sidelobes,supported by quantitative metrics(e.g.,resolution,peak sidelobe ratio,and integrated sidelobe ratio).These results indicate that the Ka-band UAV-borne SAR enables rapid,fine-grained,and repeatable monitoring of large astronomical equipment and sites.The system also shows promise for broader applications,including geohazard assessment,mining subsidence,major civil-infrastructure monitoring,power-line and pipeline inspection,and environmental monitoring.
The Accurate Infrared Magnetic Field Measurements of the Sun(AIMS)project requires a root-mean-square tracking accuracy of 1″ per 30 min to observe targets on the solar disk.Since the terminal scientific instruments in AIMS are positioned at the Coudé focus,the telescope and guiding optical path introduce slowly varying nonlinear tracking errors during solar tracking,which degrade long-duration tracking accuracy.To address this issue,we first analyze the mechanisms and characteristics of these slowly varying tracking errors at the Coudé focus,based on the optical-mechanical structure of AIMS and motion principles,and conduct actual measurements of the tracking errors.We have designed a closed-loop correction scheme in conjunction with the optical-mechanical mechanisms of AIMS,detailing both hardware and software implementations.Following over a year of testing and trial use on AIMS,results demonstrate that the system can stably perform closed-loop tracking of solar observation targets for over 30 min,with a tracking error of less than 1.0″.Both the tracking duration and error value meet tracking accuracy requirements.
The High Frequency(HF,3-30 MHz)to Very High Frequency(VHF,30-300 MHz)band is a critical observational window in radio astronomy,playing a key role in the study of early-universe reionization,space weather monitoring,and solar physics.We determine whether a genetic algorithm-optimized sparse configuration of a 64-element planar radio antenna array can minimize the peak sidelobe level and enhance performance within the 10-90 MHz frequency range,compared with a regular configuration.The sparse-optimized array achieves a 1.04 dB reduction in peak sidelobe level across the frequency band compared with the regular array.Sensitivity improves significantly at all frequency points,with increases of up to 56%at 10 MHz and 45%at 50 MHz.At 90 MHz,the sensitivity matches that of the regular array.At three representative frequencies(50 MHz,60 MHz,and 70 MHz),grating lobe suppression tests at different scan angles show that the regular array shows prominent grating lobes at specific scan angles(θ=53° at 50 MHz,θ=30° at 60 MHz,and θ=15° at 70 MHz).By contrast,the sparse array shows no observable grating lobes,confirming its superior suppression capability.At wide bandwidths,a sparse array optimized with a genetic algorithm outperforms a regular array in peak sidelobe level,sensitivity,and scanning range,supporting its use as a better technical solution for radio astronomical observations.
Universal time(UT)1 is an alternative description of the Earth’s rotation angle and is one of the spatial parameters representing the Earth’s orientation that reflects subtle changes in its rotational speed.While very long baseline interferometry(VLBI)has recently achieved high-precision measurements of UT1,its prohibitively high equipment costs and complex data processes make it difficult to meet the requirements of users in fields with stringent real-time data requirements,such as astronomical measurement and celestial navigation.Currently,the digital zenith telescope is one of the most accurate ground-based optical astronomical measurement instruments available.This study briefly introduces the digital zenith telescope measurement system and the basic principles of UT1 measurement and data processing.On the basis of more than 400 UT1 measurement experiments conducted at Luonan,Lijiang,and Delingha,the accuracy of UT1 measurements based on the digital zenith telescope is analyzed.The experimental results show that the internal consistency accuracy within 20 min can reach 10 ms and that the internal consistency accuracy of single-day observations can reach 0.05″.Compared with IERS 14C04,the mean absolute error of the UT1 measurements is approximately 3 ms.This indicates that optical astronomical observations based on the digital zenith telescope can be used as an effective regional autonomous monitoring method to supplement VLBI by providing high-frequency UT1,functioning in particular as an emergency backup when satellite navigation fails.