
2-5-Octamethylene tetrahydrophthalic anhydride does not form even a trace of the corresponding phthalic anhydride on dehydrogenation, but partly dissociates back into cyclododecadiene and maleic anhydride. 2-5-Nonamethylene tetrahydrophthalic anhydride dehydrogenates with considerable difficulty.
A survey of the heavy metal content of canned shellfish and crustaceans sold on the Canadian market has been made. With the exception of one sample of clams having 5 p.p.m. of lead, one sample of lobster having 13 p.p.m. of lead and, one sample of lobster having 7 p.p.m. of arsenic, of the 120 samples analyzed the values found were not significantly above the limits established for the heavy metal content of foods.
The effect of different amounts of starch and crude fat on humin formation during the hydrolysis of gluten prepared from a commercial flour depended on the acid/protein ratio, high ratios giving less humin nitrogen and less humin weight. The nitrogen content of humin was almost independent of the acid/protein ratio but increased with decreasing humin formation. Filtration time increased markedly with increasing purity of the samples. The color of the hydrolyzates varied slightly with impurities and acid/protein ratios.
The voluminous starch sludge or "squeegee" fraction, obtained with all known methods of wheat starch manufacture, consists of strongly hydrated pentosan masses in which starch granules are embedded. The pentosans of the bran and endosperm both contribute to the formation of these heterogeneous complexes. The "squeegee" starch fraction is not abolished by allowing the crude starch slurries to ferment, by exposing them briefly to mildly acid or alkaline solutions, or to C2−C12 monohydric alcohols. The pentosan and protein contents of this low quality starch fraction may be greatly reduced by 24–48 hr. digestion in dilute acid at pH 2.0 before recovering the starch on the centrifuge.
Experimental results are given for trials of the C.F.R. engine at 900 r.p.m. and 12: 1 C.R. on Toronto town gas alone and with an addition of hydrogen sulphide. The sulphide led to such severe preignition that measurements of power were impossible except for very weak or very rich mixtures. The former included the 50% weak mixture for which thermal efficiency is a maximum. The sulphide was then of beneficial effect, a maximum value of 44% for indicated thermal efficiency being obtained as compared to a maximum of 42.5% without it. The experimental results are interpreted in the light of combustion tube experiments showing that hydrogen in mixtures with air is not ignited by red hot surfaces on which it is oxidized with sufficient rapidity to steam, but that ignition occurs at relatively low temperatures if the surface reaction is inhibited by hydrogen sulphide. The conclusion is that fuel gases containing hydrogen in large proportion can be used for full power engine operation at compression ratios even higher than 12: 1 if the oxidation of the hydrogen in part to steam, on the hot surfaces in the combustion chamber, is not inhibited by the poisoning effect of the hydrogen sulphide commonly present in the gases.