Recently, Sliding electrical contacts are used in severe operating conditions, such as high temperatures, very low temperatures and ultra-high vaccums. They also require high reliability. In this research, three kinds of composite materials, containing different elements, make use of WS2 show excellent characteristics in the atmospheres mentioned above. A Cu disk was examined as a partner materials. Consequently, it becomes clear that composite materials containing the smallest quantity (30 wt.%) have excellent characteristics in contact resistance and coefficient of friction.
When investigating fuel cell stack design and performance detailed stack modeling is needed. By using a combination of the commercial software MATLAB and COMSOL, a stack model has been developed. The model incorporates a flow network model (FNM) and a 2D finite element method (FEM) model. The FNM model initially calculates the flow distribution in the stack, and transfers this information to the FEM model. The FEM model solves for electron transport, thermal conduction and simplified reactant and coolant transport. This stack model is validated and used to investigate the behaviour of a stack and individual cells under various operating conditions, with a special focus on cell-to-cell electrical coupling. Furthermore the effects of changing flow header dimensions are investigated. This type of modeling is well suited for initial stack performance estimates, and tests of worst case scenarios. This can contribute to faster stack design iterations.
Gold plates are widely used for high performance connectors. Pure gold is very soft. In order to improve the wear resistance of gold plates, hard gold is usually used. The high hardness is achieved by alloying elements such as cobalt, iron or nickel. With an increasing rate of alloying elements the hardness of gold plates is increased. On the other hand, the alloying elements decrease the electrical conductivity, the corrosion resistance and the formability of gold plates. Our investigation shows that the wear rate of the hard gold plates at the contact area is still very high. The depth of the crater at the contact area very soon exceeds the thickness of the gold plates during the wear tests. Since the nickel underplate, the barrier layer, is very sensitive to fretting corrosion, the electric contacts must electrically fail at this stage, due to the strong increase of contact resistance. However, many electric contacts do not fail at this stage and at stages far beyond. Two very different wear patterns are the reasons for this phenomenon.Different amounts of gold, alloying elements, nickel and elements of base metals can be found at the bottom of the crater at the contact area by means of energy dispersive X-ray analysis (EDX). Depending on the lateral and spatial distribution of these elements, quite different electrical behavior of electric contacts can be observed.Therefore achieving the favored wear pattern, not increasing wear resistance alone, should be the target of modification of plating materials for increasing the lifetime of electric contacts.
