
Microcalorimetry was used to determine the vitamin E (tocopherol) content in cedar nut oils obtained via different processing methods from nuts harvested in different years. The analytical method employed is kinetic in nature, relying on the ability of tocopherol to act as an antioxidant and inhibit a model liquid-phase radical oxidation reaction. The study demonstrates that, depending on the raw material, the tocopherol content in cold-pressed oils ranges from 37 to 60 mg%. Higher tocopherol levels indicate oil adulteration. Solvent-extracted cedar oils do not exhibit elevated antioxidant levels, suggesting that the use of solvents is not advisable—particularly given that cedar oil is often regarded as a therapeutic product. It was found that high-quality oil with an initially low peroxide value stores well under refrigeration, with no decline in vitamin E concentration over the course of a year. Storage at room temperature significantly accelerates oxidation; the tocopherol concentration drops by 50% within a year, and heating in air at 40°C for one month causes the level to approach zero. Encapsulated oil oxidizes much more slowly, allowing manufacturers to extend the shelf life to two years. The study also shows that adding oleoresin or dihydroquercetin to cedar oil more than doubles the product's antioxidant activity.
Catalytic oxidation of pine wood (Pinus sylvestris) with oxygen produces high yields of vanillin. The influence of mass transfer intensity on the oxidation process rate and selectivity has been little studied. It was shown that size of wood particles (fractions less than 2 mm) does not significantly affect the rate of oxidation or the maximum yield of vanillin. The highest recorded yields (up to 35–36 wt.% based on the initial lignin) exceeded those obtained from pine wood oxidation with nitrobenzene (23–27 wt.%). The high vanillin yields were confirmed by weight analysis, GLC, 1H NMR methods. The results obtained indicate that in order to attain high vanillin yields from native lignin oxidation with oxygen it is sufficient to use sawdust with a fineness of 2 mm or less, and finer grinding the wood is not required. Vibrational wet milling disrupts the anatomic porous structure of wood, increases resistant to oxidation and decreases vanillin yield.
The article is devoted to the comparative characteristics of non-specific enzymatic hydrolysis of a chitosan-glucan complex from higher fungi and chitosan from crustaceans for the production of chitooligosaccharides and evaluation of their physicochemical properties. The objects of study were the chitosan-glucan complex from fruit bodies of Ganoderma lucidum and commercial chitosan used for comparative evaluation. Enzymatic hydrolysis of samples was carried out using the preparation "CelloLux-A" (cellulolytic activity – 6000 U/ml, xylanase activity – 1700 U/ml). Physicochemical properties were determined by viscometry and potentiometric titration. As a result of the research, technological parameters of enzymatic treatment of chitosan-glucan complexes and chitosan for chitooligosaccharides production have been developed: temperature 55.0 °C; pH 5.5; enzyme preparation concentration from 1.2 to 1.4%; duration of enzymatic hydrolysis – 24–26 h; concentration of chitosan-glucan complex and chitosan solution – 3.0%; solvent – 1.0% aqueous acetic acid solution. The yield of chitooligosaccharides from the chitosan-glucan complex was 78.4%, from chitosan – 94.5%. It was found that enzymatic hydrolysis of the chitosan-glucan complex by "Cellolux-A" proceeds via a mechanism involving the hydrolysis of β-(1→4)-glycosidic bonds in chitosan and β-(1→3)- and β-(1→6)-glycosidic bonds in glucans, leading to the release of the chitosan chain from the complex with subsequent formation of low-molecular-weight fragments. IR spectra analysis showed preservation of the chemical structure of monomeric units of chitooligosaccharides during hydrolysis and the occurrence of depolymerization. Chitooligosaccharides from chitosan were characterized by higher values of intrinsic viscosity (4.1 dl×g-1), molecular weight (5.4 kDa) and degree of deacetylation (91.5%), exceeding the corresponding values for chitooligosaccharides from the chitosan-glucan complex by 7.9, 68.8 and 24.3%, respectively. It is shown that the use of cellulase
The dried aboveground parts (leaves and stems) of 3 plant species were used as studied objects: nettle (Urtica dioica L. – Urticaceae), trifid bur-marigold (Bidens tripartita – Asteraceae) and Sage (Salvia officinalis – Lamiaceae). The goal of the work presented is to determine the total content of tannins, flavonoids and polyphenolic compounds in chosen plant species. Permanganatometry method was chosen for detecting of tannins, determination of flavonoids and polyphenolic compounds was carried out by using UV-spectrophotometry method. Determination of tannins content in aqueous and alcoholic plant extracts by permanganatometry method was carried out. The obtained data indicate the highest percentage of tannins for the alcoholic extract of nettle obtained by Soxhlet extraction, as well as for aqueous and alcoholic extracts of trifid bur-marigold, obtained by ultrasonic extraction. The study of the quantitative content of polyphenolic compounds showed the advantage of ultrasonic extraction of active agents for nettle and the advantage of Soxhlet extraction of active agents for sage. During the detection of flavonoid content, it was determined that the most active agent yield is achieved for trifid bur-marigold during the process of ultrasonic extraction. The most favored extraction methods for each of the selected plant species were determined. The information obtained is planned to be used for further creating of prototype of a protein-based matrix with integrated plant extracts as active wound healing and antibacterial agents.
Natural dyes are natural chemical compounds that are found in various foods or biological objects. Chlorophylls are one of the most well-known biologically active compounds and, according to scientific literature, have a positive effect on health due to their anti-inflammatory, antitumor, regenerative and antimutagenic properties. One of the most possible mechanisms of action of chlorophylls and its derivatives is their antioxidant properties. The aim of the study was to study the antioxidant properties of chlorophyll derivatives and commercial products based on drinking chlorophyll. To isolate natural chlorophyll, a tincture of stinging nettle leaves (Urtica dioica L.) was obtained in a ratio of 1 : 5 (raw material: 96% ethyl alcohol). The tincture was evaporated and mixed with silica gel for column chromatography, dried to obtain a loose powder. The separation was performed using vacuum chromatography on silica gel. Adsorption liquid column chromatography was performed to extract the copper chlorophyll complex from the factory stinging nettle leaves extract. The chlorophylls studied in the experiment, isolated from factory extracts and tincture of leaves of stinging nettle, occupied an intermediate position in terms of total antioxidant activity between ascorbic acid and synthetic antioxidant (trolox). Almost all of the studied samples (taking into account the chlorophyll content) showed higher antioxidant activity than ascorbic acid.