
Advanced Meat Recovery (AMR) is a USDA-approved method for recovering residual edible tissue from beef bones following deboning. However, no recent work has evaluated product quality across varying AMR inclusion levels. Therefore, the objective of this study was to determine the effects of increasing AMR inclusion on ground beef quality. Ten batches of 6 treatments: Fed (fed trim), 0% AMR (nonfed trim), and 4 AMR treatments (5%, 10%, 15%, and 20% in nonfed trim) were formulated to a targeted lean:fat (81:19) ratio (N = 60). Treatments were ground, formed into patties, and displayed for 0, 4, or 7 days. Patties were analyzed for proximate analysis, collagen, iron, and calcium content, aerobic plate count (APC), pH, lipid oxidation, instrumental and cooked color/yield, texture profile analysis (TPA), and trained sensory analysis. Calcium, iron, pH, and APC increased with AMR incorporation relative to the 0% AMR control (P < 0.05), whereas collagen content did not differ (P > 0.05). There was a noted increase in lipid oxidation for the 10% AMR patties after 7 days of retail display (P < 0.05). Generally, AMR patties had lower a* and b* values than 0% AMR patties (P < 0.05); however, discoloration and L* were unaffected by AMR inclusion (P > 0.05). Exterior cooked b* and internal cooked L* decreased (P < 0.05) with high levels of AMR inclusion (P < 0.05). TPA showed AMR patties were softer and less chewy than controls when cooked to an internal temperature of 71°C (P < 0.05). However, sensory analysis indicated AMR patties were less juicy and chewier, but with reduced connective tissue, when cooked to an internal temperature of 74°C (P < 0.05). Overall, AMR inclusion up to 20% produced only minor quality changes, supporting the potential inclusion of AMR in fresh ground beef production.
Limited studies have examined how cyclodextrin-encapsulated antioxidants influence lipid and myoglobin stability. The objective was to investigate the effects of cyclodextrin-encapsulated citral, coenzyme Q10, and curcumin on myoglobin and lipid oxidation in a beef sarcoplasm–liposome model. Two separate experiments were conducted to study the effects of cyclodextrin-encapsulated antioxidants on lipid oxidation. In experiment 1, radical-scavenging properties of cyclodextrin-encapsulated citral, coenzyme Q10, and curcumin were measured at 0.002%, 0.02%, and 0.2% using ABTS (2,2′-azino-bis[3-ethylbenzothiazoline-6-sulfonic acid]) and DPPH (2,2-diphenyl-1-picrylhydrazyl) assays, with rosemary and ascorbic acid as reference antioxidants. From experiment 1, 0.2% was selected for experiment 2, in which each encap- sulated antioxidant treatment was added to a beef sarcoplasm–liposome model. Sarcoplasm was extracted from 6 different beef Longissimus lumborum muscles (14-d postmortem) and mixed with a phosphatidylcholine-based liposome preparation (n = 6 biological replications). All 3 antioxidants were added at 0.2%, and the mixture was incubated at 37°C for 6 h. During incubation, metmyoglobin formation, lipid oxidation, and antioxidant activity (ABTS and DPPH) were determined. In experiment 1, addition of encapsulated antioxidants increased radical-scavenging potential (P < .05), with curcumin displaying the highest radical scavenging (P < .05) compared to all other treatments. Furthermore, curcumin decreased (P < .05) hydrogen peroxide-mediated ferryl myoglobin formation compared with other treatments. In experiment 2, addition of cyclodextrin-encapsulated curcumin decreased (P < .05) both lipid oxidation and metmyoglobin formation at 6 h of incubation compared with control and coenzyme Q10 in sarcoplasm–liposome samples (curcumin < citral < coenzyme Q10; P < .05). Overall, cyclodextrin-encapsulated antioxidants effectively limited oxidative deterioration in the beef sarcoplasm–liposome system, with efficacy strongly dependent on the antioxidant mode of action. Curcumin and citral provided greater protection against both lipid and myoglobin oxidation than coenzyme Q10, demonstrating that antioxidant selection is critical for maximizing oxidative stability in meat systems.
USDA Prime carcass numbers have risen steadily over the past 25 years, but the grade remains undifferentiated in value-based marketing programs. As Prime availability grows, opportunities exist to capture added value by differentiating this grade, similar to what has been done within the USDA Choice grade. Therefore, the objective of this study was to evaluate palatability characteristics of strip loin steaks from upper 2/3 Prime (Super Prime), Low Prime, Upper 2/3 Choice, and Low Choice across 3 degrees of doneness (DOD): Rare (R), Medium (MED), and Well-Done (WD). Steaks were designated for consumer evaluation, trained sensory evaluation, or objective quality measurements. There were no (P > 0.05) quality grade × DOD interactions for any consumer- or trained panel-evaluated traits. Super Prime steaks were rated higher (P < 0.05) for all sensory traits evaluated by consumers and trained panelists compared to all other grades. Low Prime, Top Choice, and Low Choice did not differ (P > 0.05) for juiciness, flavor, or overall liking, although Low Prime was more tender (P < 0.05) than Low Choice for consumers. A higher percentage (P < 0.05) of Super Prime steaks were rated as acceptable for juiciness, flavor, and overall liking than all other quality grades. R steaks were rated juicier and more tender (P < 0.05) than MED and WD steaks, whereas MED and WD samples were similar (P > 0.05) for those traits. Across all DODs, Super Prime steaks had the lowest (P < 0.05) Warner-Bratzler shear force. These results indicate that consumers preferred the eating quality of upper 2/3 Prime steaks over the other grades evaluated and support the opportunity for premium programs within the Prime grade, offering the beef industry a valuable opportunity to capture added value from this highest grade within beef.
Natural casings derived from sheep (NC-S) and pig intestines are valued for their desirable organoleptic attributes, including elasticity, tenderness, and the characteristic “ snap ” upon biting. However, their high cost, dimensional inconsistency, and labor-intensive processing present ongoing challenges. Currently the coextruded casings produced from bovine hide collagen (HC-B) offer a scalable alternative but still show lower sensory and cooking performance. This study evaluated concept formulations for coextrusion gels produced from porcine collagen sources—urinary bladder and intestine—as potential alternative raw materials. Warner-Bratzler shear force data were analyzed using a linear mixed- effects model accounting for experimental phase and production trial. Casing type had a significant effect on shear force (P = .022). NC-S exhibited the highest adjusted mean shear force (56.9 N) followed by porcine bladder collagen (BC-P; 42.6 N), bladder-intestine collagen (38.2 N), and HC-B (31.2 N). Tukey-adjusted pairwise comparisons showed that NC-S had a significantly higher shear force than HC-B, whereas no significant differences were observed between the porcine-derived casings and either reference casing type. Qualitative visual assessment suggested less extensive blistering in porcine-derived casings than in HC-B after reheating. Collectively, these finding demonstrate the feasibility of processing BC-P, alone or in combination with intestinal collagen, into gels for coextruded sausage casings. Their intermediate shear-force characteristics and qualitative-reheating observations support further optimization and validation of these alter- native collagen sources. Their use may also contribute to the valorization of underutilized porcine byproducts.
As camera grading technologies improve, the utilization of these data to characterize carcass color on a continuous scale provides an opportunity to improve the identification and classification of carcass quality in relation to color. One week of instrumental grading data from cattle under 30 months of age was collected from two commercial abattoirs per month from June 2023 to March 2024 (n = 457,026 carcasses). Mean hot carcass weight (HCW) was 397.1 kg, marbling score 505.4, vision yield grade (VYG) 3.2, backfat thickness 1.55 cm, ribeye area (REA) 93.7 cm2, and color score 71.9. The frequency of USDA quality grades was 7.27% Prime, 72.40% Choice, 19.14% Select, and 1.19% received other grades. The distribution of USDA Yield Grade (YG) was 10.89% YG1, 31.92% YG2, 35.57% YG3, 17.09% YG4, and 4.54% YG5. Furthermore, 72.64% of cattle were English breeds, 13.03% Exotic breeds, 12.14% Beef × Dairy, 2.00% Bos indicus, and 0.20% Dairy. Carcasses were categorized based upon the camera color score: dark (DARK; color score ≤ 55), intermediate (INT; 55 < color score ≤ 59), normal (NORM; 60 ≤ color score < 80), and light (LIGHT; color score ≥ 80). The color category distribution was 0.33% DARK, 1.21% INT, 87.74% NORM, and 8.72% LIGHT. All data were analyzed using a generalized mixed linear model with significance declared at P ≤ 0.05. Dark and INT carcasses had the least (P < 0.05) HCW, marbling score, VYG, and backfat thickness. Light carcasses had the greatest (P < 0.05) HCW, marbling score, VYG, and backfat thickness. The results of this support previous trends within the United States Beef industry and demonstrate that grading cameras can further classify beef carcasses by color classification. There is variation in the composition of carcasses from the different color categories, wherein DARK and INT carcasses are similar in most parameters, while NORM and LIGHT are compositionally independent.