
Microplastic contamination in aquatic environments and its effects across trophic levels require further elucidation. This study evaluated the effects of conventional and biodegradable microplastics, namely high-density polyethylene (HDPE), polybutylene succinate (PBS), and thermoplastic starch (TPS), on two model species representing different levels of aquatic food webs: the brine shrimp (Artemia salina) and the Asian seabass (Lates calcarifer). In A. salina nauplii, acute toxicity was evaluated after 24 and 72 h of exposure to 25, 50, and 100 μg/mL. At 24 h, TPS did not significantly affect the survival rate (84.0–96.0%), whereas survival was significantly reduced by HDPE at 100 μg/mL (65.2%) and by PBS at 50 and 100 μg/mL (77.3%) (p < 0.05). At 72 h, the survival rate decreased significantly at the highest concentration (100 μg/mL), with the lowest value in the PBS group (57.9%), followed by HDPE (60.0%) and TPS (66.7%) (p < 0.05). None of the microplastics affected the hatching of decapsulated cysts within 24 h. In L. calcarifer fed diets containing 100 mg/kg of microplastics, HDPE transiently reduced acetylcholinesterase (AChE) activity in the gills and intestine at 24 h, with recovery by 72 h. PBS reduced AChE activity in the gills at 24 h and in the intestine at 72 h, whereas TPS caused no significant change in any tissue; brain AChE was unaffected by any treatment. Fourier-transform infrared (FTIR) microspectroscopy indicated tissue-specific alterations in lipid and protein composition and in protein secondary structure, particularly in the brain and intestine. These findings indicate that thebiodegradable polymer (PBS) is not necessarily less harmful than conventional HDPE and may pose sub-lethal risks to aquatic organisms, whereas TPS showed no effect on fish AChE under the conditions test.
The widespread use of synthetic materials in sportswear has raised concerns regarding the release of fiber fragments during laundering and their contribution to environmental plastic pollution. This study investigated the release of fiber fragments during washing of various synthetic sportswear items such as polyester (PET), recycled polyester (rPET), polyamide/elastane (PA/EL), recycled polyamide/elastane (rPA/EL), as well as prewashed PA/EL samples. The processing of aqueous effluents consisted of filtering the entire washing solution (150 mL) and rinsing water (200 mL) using different filters for fraction separation. The higher release of fiber fragments observed by optical microscopy is supported by the PA/EL (204 fiber fragments/g of textile material), while the rPET shed 88 fiber fragments/g of textile material. Furthermore, the long washing cycles led to a reduced number of fiber fragments (about 57 fiber fragments/g of textile material for the PA/EL-W50 sample). Also, the perforated fabric structure promoted the release of 153 fiber fragments/g of textile sample. The PA/EL and PA/EL/P-W50 samples shed a high abundance of fiber fragments smaller than 500 µm after washing.
Plastic pollution is an increasing threat to marine biodiversity, ecosystem functioning, and potentially human health. Addressing marine plastic pollution requires assessment approaches linking environmental and human health within interconnected compartments. The national BioPlast4Safe Project addresses this challenge through a multidisciplinary framework based on One Health principles, to improve risk assessment strategies for micro- and nano-plastics (MPs and NPs) from both conventional and biodegradable polymers. In this context, the ecotoxicity of MPs (size 20–38 μm) of polypropylene (PP) and biodegradable polylactic acid (PLA) derived from commercial plastic cups was investigated by an ecotoxicological battery of marine species (bacteria, algae and crustaceans). The ecotoxicological results showed that: (i) both polymers induced mainly adverse effects in the four invertebrates (almost always 50% effect was observed up to 100 mg/L), but not in algae (Dunaliella tertiolecta) and bacteria (Aliivibrio fischeri); (ii) three species (Corophium insidiosum, Cymodoce truncata and Gammarus aequicauda) highlighted no statistically significant difference in biological response between the two polymers and only one species (Tigriopus fulvus) showed EC50 values significantly lower for PP-MPs than PLA-MPs values; (iii) the different size of the MPs did not result in a different biological response. This study provides an exploratory assessment of the potential hazard posed by PLA- and PP-MPs in the marine environment, although limitations in taxonomic coverage require the findings to be interpreted as provisional. Hazard was assessed using a probabilistic species sensitivity distribution (pSSD) approach, integrating BioPlast4Safe experimental results with published ecotoxicological data to derive the hazard concentration values expected to affect 5% of the biological community (HC5). The estimated probabilistic distributions of mass-based HC5 values yielded a lower mean estimate for PP-MPs (0.09 mg/L; 95% CI: 0.03–0.15 mg/L) than for PLA-MPs (0.40 mg/L; 95% CI: 0.19–0.65 mg/L), corresponding to an approximately fourfold difference. However, the ecological significance of this difference should be interpreted cautiously, considering the uncertainties associated with the assessment, including those arising from the limited taxonomic coverage of the datasets. Overall, our results support that the biodegradable PLA should not automatically be considered environmentally harmless, as PLA-MPs also exhibited measurable ecotoxicological effects, although their estimated HC5 values were higher than those of PP-MPs. These exploratory findings provide an initial basis for comparing the potential hazards of biodegradable and conventional materials and underscore the importance of assessing the ecotoxicological hazards of biodegradable alternatives, alongside the need for broader ecotoxicological datasets to support robust community-level hazard assessment.
Micro–nanoplastics (MNPs) have emerged as a critical environmental pollutant with significant potential implications for the development of liver disease. These MNPs can accumulate in the liver, initiating a series of detrimental biological responses. One of the main mechanisms is the initiation of oxidative stress, which is marked by overproduction of reactive oxygen species harming cellular structures. This oxidative damage is closely linked to hepatic inflammation, where immune responses are triggered, exacerbating tissue injury and disrupting normal liver function. As a result, hepatic metabolism, detoxification, and immune regulation become compromised due to persistent MNPs exposure. Although in vitro and vivo models effectively show direct cellular toxicity, oxidative stress, and metabolic disruption, direct evidence from human studies is mostly confined to tissue detection and cross-sectional correlations. As a result, advanced pathological outcomes like the progression of hepatic fibrosis and the development of cancer are considered mechanistic hypotheses grounded in biological plausibility rather than confirmed human causation.
Indoor air is likely a major route of human exposure to microplastics (MPs), yet indoor airborne concentrations from active sampling span nearly four orders of magnitude, from below 1 to more than 1000 particles m−3. We assessed whether this variability reflects real differences or methodological heterogeneity by synthesizing 33 primary studies (2017–2026) on MPs in indoor air, deposition, settled dust and air-conditioner filters, recording the sample type, lower size limit and identification technique. Reported concentrations were negatively associated with the lower size limit (Spearman’s ρ = −0.58, 95% CI −0.88 to 0.05, n = 12), and the particles counted changed with it: studies resolving particles of a few micrometers were dominated by fragments, whereas those limited to larger particles found mainly fibers. Sample type and spectroscopic confirmation further shaped reported abundances. Polyester, polyamide, polypropylene and polyethylene prevailed across settings, pointing to textiles and furnishings as the main sources. MPs have been detected in human lung tissue and sputum, but estimated inhalation doses range from tens to tens of thousands of particles per day. Comparing indoor MP concentrations without accounting for methodological factors risks mistaking measurement differences for differences in exposure. We identify priorities for harmonized reporting, size-resolved sampling and exposure-relevant toxicology.