
Carbon fiber reinforced plastic (CFRP) is a composite material made of carbon fibers and resin, and is widely used because of its light weight, corrosion resistance, and durability. However, its excellent properties make it difficult to recycle, and most of the CFRP waste is landfilled. A new recycling technology to recover the carbon fiber from waste CFRP is desired. In this study, a new method to decompose the resin part by heating waste CFRP with sodium hydroxide (NaOH) to recover the carbon fibers with high strength was investigated. Waste CFRP was heated with NaOH under nitrogen atmosphere at 200-600℃ for 0-90 min, then washed with distilled water, and sieved to recover the high- strength carbon fiber. By heating without NaOH, it is diffi cult to separate the fiber from resin. By heating with NaOH, carbon fiber with high strength can be recovered at 250-350℃ by hydrolysis reaction of resin with NaOH and distilled water, while those with low strength at higher than 400℃, due to the pyrolysis reaction of resin and carbon fiber. By immersing the CFRP into NaOH at 300℃, long length carbon fiber with high strength can be recovered.
This study used three tertiary amine solutions as a CO2 absorbent. Ultrasound can desorb CO2 from CO2(aq) and H2CO3 species at low temperature. Tertiary amine solution with lower pKa created CO2 adsorption equilibrium at lower pH related to a higher CO2 desorption amount using 28 kHz ultrasound because the lower pH environment would increase the existence ratio of CO2(aq). Triethanolamine (TEA) with lowest pKa (7.85) showed the highest CO2 desorption ratio of 48% for 30 min irradiation at 25 °C. The CO2 absorption–desorption capacity of TEA by reuse was evaluated and found to keep the first capacity for three cycles.