
Extracting the maximum value from data obtained by smart sensors will require identifying and leveraging trends and mutual information in raw data, calibration measurements, and telemetry data. Use of machine learning algorithms enables the extraction of information content which is not exploited by current approaches. To reduce power draw of radiometric sensors, we propose an approach using machine learning to produce calibrated radiometer measurements prior to reaching steady state. By enabling calibration during instrument power cycling, or between instrument turn-on and reaching equilibrium, the average power draw of the sensor can be reduced, while reducing gaps in data acquisition and increasing capabilities of existing sensor platforms.
The high global burden of stroke presents unique clinical challenges, and morbidity is high in treatable patients despite prevalent research and development in stroke diagnosis. Differentiation between ischemic and hemorrhagic stroke is the foremost diagnostic step, so precise detection or exclusion of intracranial hemorrhage is a high-impact objective in stroke cases. To develop microwave imaging prototypes, experiments must be performed with material composites with realistic tissue properties, known as phantoms. Relevant factors, methods, and data for hemorrhagic lesion phantoms are presented.
Joesphson parametric amplifiers (JPA), operating in the microwave regime, are a key component for quantum radar. A Josephson junction can combine the functions of local oscillator, mixer, amplifier and detector. For quantum radar based on two-mode squeezed vacuum states (TMSV), the Josephson devices perform squeezed state generation and mixing, for subsequent photon counting and hypothesis testing. In this contribution, we investigate quantum circuit for modeling of JPAs.
This study presents an analytical design of a new compact coplanar waveguide (CPW) fed ultra-wideband (UWB) antenna operable in the spectrum between 23–150 GHz. It exhibits remarkable performance in the mm-Wave Spectrum with simulated radiation efficiency over 90% and gain over 4.5 dBi in the entire band. Moreover, with a 147.2% fractional bandwidth, this newly proposed miniaturized antenna (17 x 15 x 0.787 mm 3 ) is envisaged to be deployed for the higher band of 5G as well as the next generation 6G wireless communication.
This paper presents the conceptual design of an electrically small antenna (ESA) for transmitting arbitrary wideband signals. Using an ESA, the antenna system converts the baseband I/Q of a broadband signal to a circularly polarized waveform. Consequently, the bandwidth of the transmitted signal is orders of magnitude broader than the antenna’s instantaneous bandwidth. The full-wave simulation results of the antenna system are imported into a circuit simulator to evaluate its performance. These simulation results demonstrate that the proposed method for transmitting an arbitrary waveform from an ESA is effective.