Hybrid joints made of steel and aluminium alloy produced by rotary friction welding enable load-adapted lightweight components. However, a major challenge is the inhomogeneous radial temperature distribution caused by different relative velocities between the specimen centre and edge during rotation. This effect leads to local insufficient bonding and reduces the overall joint strength, especially in the centre, where low relative rotation speeds occur. Previous studies mainly addressed preheating before the friction phase, whereas superimposed heating during the upsetting phase has not been investigated so far. To achieve temperature equalisation along the cross-section during rotary friction welding, a modified KUKA Genius plus machine equipped with joule heating was used to introduce an electric current during the upsetting phase. Experiments were conducted on EN AW-6082 (AA-6082) joined to 20MnCr5 (AISI 5120H). A three-step variation of current intensity (10, 24 and 36 A/mm 2 ), alongside a reference without current, was investigated. Temperatures were monitored using type K thermocouples, confirming temperature equalisation. Mechanical performance was assessed by uniaxial tensile tests, while hardness measurements and metallographic analyses characterised the influence of superimposed heating on the interfacial microstructure. Joint strength improves up to 17% with increasing current, even under otherwise unsuitable welding parameters that would normally result in insufficient bond strength. This improvement is linked to a uniform temperature distribution and enhanced material flow, resulting in a defect-free specimen centre.
原文链接
分享
引用
