Virtual Aggregate Interlock Testing Using Real Crack Surfaces from 3d Scanning

Aggregate interlock is considered one of the most important shear transfer mechanisms in concrete members. In the well-established Two-Phase model proposed by Walraven in the 1980s, the shear stress transferred by aggregate interlock is estimated by calculating the projected contact areas of two crack surfaces. As one of the main assumptions in the model, the crack surface is idealized by a plain surface crossing randomly distributed, idealized spherical aggregates. This was a necessary simplification of an actual crack surface in the 1980s because of the lack of measurement equipment as well as computational capacity. With the development of high-accuracy 3D scanning techniques, new possibilities for modelling aggregate interlock have become available. This paper proposes a generalised method to determine the aggregate interlock stresses using the crack surface directly from 3D scanning. The proposed method is cross-verified with the Two-Phase model using the same simplified crack surface. A case study using the scanned crack surfaces of concrete cubes is conducted to investigate the influence of surface roughness. The proposed method provides a new possibility for conducting a refined investigation of the aggregate interlock for new concrete types, especially under the scope of the next-generation Eurocode shear provision.