谷歌浏览器插件
订阅小程序
在清言上使用

Comparison of Calibration Procedures for 192ir High-Dose-rate Brachytherapy Sources.

D Baltas,K Geramani, GT Ioannidis, K Hierholz,B Rogge,C Kolotas,K Muller-Sievers, N Milickovic,B Kober,N Zamboglou

International journal of radiation oncology, biology, physics(1999)

引用 45|浏览13
暂无评分
摘要
Purpose: To compare the efficacy of different calibration procedures for Ir-192 high-dose-rate (KDR) brachytherapy sources and to determine their suitability in clinical practice. In addition the manufacturer's calibration is compared with our experimental measurements so that the accuracy of the source strength on the manufacturer certificate which is supplied with each new Ir-192 source can be accessed.Methods and Materials: We compared three types of calibration system: well-type chambers (HDR-1000 and SDS), cylindrical phantom, and plate phantom, The total number of measurements we obtained was 365, The number of sources used for the calibration procedure comparison was 20 and the number used for comparison with the manufacturer's calibration was 46. This study was made during the period 1989-1997. Also, Physikalisch-Technische Bundesanstalt (PTB) calibrated one of our sources using their PTB protocol so that the results could be compared with our own.Results: The sensitivity of each system on scattering from the room walls was studied. It was found that different minimum lateral distances from the walls were required for the different systems tested: 15 cm and 25 cm for the well-type chambers, 75 cm for the cylindrical phantom, and 13 cm for the plate phantom, The minimum thickness required to reach phantom scattering saturation for the plate phantom setup is 24 cm, The influence of the applicator material used in the calibration setup was found to be 1.7% for the stainless steel dosimetry applicator compared to the plastic 5F applicator. The accuracy of source positioning within the applicator can lead to dosimetric errors of +/-1.2% for the radial distance of 8.0 cm used with both solid phantoms, The change in the response for both well-type chambers was only 0.1% for changes in the source position within +/-7.5 mm around the response peak. Good agreement was found between all dosimetry systems included in our study. Taking the HDR-1000 well-type chamber results as a reference, we observed percentage root mean square (RMS) values of 0.11% for the SDS well-type chamber, 0.44% for the cylindrical, and 0.60% for the plate phantom setup. A comparison of our results using the cylindrical phantom with those of the manufacturer showed a percentage RMS value of 3.3% with a percentage fractional error range of -13.0% to +/-6.0%. The comparison of our calibration results with those of PTB gave deviations less than 0.4% for all systems.Conclusions: Our results have shown that with careful use of all calibration system protocols an accurate determination of source strength can be obtained. However, the manufacturer's calibration is not accurate enough on its own, and it should be mandatory for clinics to always measure the source strength of newly delivered Ir-192 brachytherapy sources. The influence of the applicator material, metal or plastic, should always be taken into account. (C) 1999 Elsevier Science Inc.
更多
查看译文
关键词
HDR brachytherapy,Ir-192 source calibration,well-type ionization chambers,solid-state phantoms
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要