The Vtr Project: Architecture And Cad For Fpgas From Verilog To Routing

To facilitate the development of future FPGA architectures and CAD - tools both embedded programmable fabrics and pure-play FPGAs - there is a need for a large scale, publicly available software suite that can synthesize circuits into easily-described hypothetical FPGA architectures. These circuits should be captured at the HIM, level, or higher, and pass through logical and physical synthesis. Such a tool must provide detailed modelling of area, performance and energy to enable architecture exploration. As software flows themselves evolve to permit design capture at ever higher levels of abstraction, this downstream full-implementation flow will always be required. This paper describes the current status and new release of an ongoing effort to create such a flow the 'Verilog to Routing' (VTR) project, which is a broad collaboration of researchers. There are three core tools: ODIN II [10] for Verilog Elaboration and front-end hard-block synthesis, ABC [16] for logic synthesis, and VPR [13] for physical synthesis and analysis. ODIN II now has a simulation capability to help verify that its output is correct, as well as specialized synthesis at the elaboration step for multipliers and memories. ABC is used to optimize the 'soft' logic of the FPGA. The VPR-based packing, placement and routing is now fully timing-driven (the previous release was not) and includes new capability to target complex logic blocks. In addition we have added a set of four large benchmark circuits to a suite of previously-released Verilog HDL circuits. Finally, we illustrate the use of the new flow by using it to help architect a floating-point unit in an FPGA., and contrast it with a prior, much longer effort that was required to do the same thing.