Stiffness of modified Type 1a linear external skeletal fixators.

Modifications of a Type 1a external skeletal fixotor (ESF) frame were evaluated by alternately placing transfixation pins on opposite sides of the connecting rod (Type 1a-MOD) or by placing additional connecting rods on either of the two inside (Type 1a-INSIDE) or two outside (Type 1a-OUTSIDE) transfixation pins. The objective of this study was to evaluate the stiffness of these modifications in terms of axial compression (AC), craniol-caudal bending (CCB), and medial-lateral bending (MLB). We hypothesized that these designs would allow significant increase in unilateral frame stiffness, over Type 1a, without proportional increase in frame complexity or technical difficulty of application. All of the ESF frames were constructed using large IMEX SK(TM) clamps, 3.2 mm threaded fixation pins, 9.5 mm carbon fibre connecting rods and Delrin rods as bone models. Nine, eight pin frames of each design were constructed, and subjected to repetitive non-destructive loading forces (AC, CCB, MLB) using a materials testing machine. Frame construct stiffness for each force (AC, CCB, MLB) was derived from load-deformation curve analysis and displayed in N/mm. Data revealed the 1a-MOD and I a-OUTSIDE constructs had significantly increased stiffness in CCB and AC as compared to the Type 1a constructs while all of the modified constructs were significantly stiffer in MLB than the Type 1a constructs.