Improvement On Opc Completeness Through Pre-Opc Hot Spot Detection And Fix

DESIGN FOR MANUFACTURABILITY THROUGH DESIGN-PROCESS INTEGRATION II(2008)

引用 10|浏览6
暂无评分
摘要
Design For Manufacturing (DFM) has been paid attention as the feature size on chip goes down below the k1 factor of 0.25. Lots of DIM related ideas have been come up, tried, and some of them adopted for wider process window and as a result, higher yield. As the minimum features are getting shrunk, the design rules become more complicated, but still not good enough to describe the complexity and limitation of certain patterns that imposes narrow process window, or even failure of device. Thus, it becomes essential to identify, correct, or remove the litho-unfriendly patterns (more widely called as hot spots), before OPC. One of the efforts is to write a DFM rules in addition to conventional DRC rules. In this study, we use the software, called YAM (Yield Analysis Module) to detect hot spots on pre-OPC layouts. Conventional DRC-based search is not able to surpass YAM, as it enables to identify hot spots in either much easier way or even ones that are unable to be found by DRC. We have developed a sophisticated methodology to detect and fix OPC- and/or litho-unfriendly patterns. It is confirmed to enlarge process window and the degree of freedom on OPC work.
更多
查看译文
关键词
OPC,DFM,process window,design rule,YAM,DRC
AI 理解论文
溯源树
样例
生成溯源树,研究论文发展脉络
Chat Paper
正在生成论文摘要