Determination Of Residual Stresses Using Laser-Generated Surface Skimming Longitudinal Waves

A laser-ultrasonic technique is described to non-destructively determine residual stresses in metals such as those produced by shot peening. The method is based on monitoring the small ultrasonic velocity change of the laser-generated surface skimming longitudinal wave (LSSLW) propagating just below the surface. The main advantage of using LSSLW is that the effect of surface roughness induced by shot peening is greatly reduced compared to using surface acoustic waves (SAW). To improve resolution in the measurement of small velocity changes, a cross-correlation technique is used with a reference signal taken on the same but unstressed material in similar conditions. Also, the low-frequency SAW can be used to correct the LSSLW results when affected by minute changes in the path length during the measurements. The validity of the approach is demonstrated by measuring quantitatively the near surface stress in a four-point bending experiment with different levels of surface roughness. Then, scanning results on properly and improperly laser shock peened samples are reported. In particular, the LSSLW velocity variations for the properly peened samples clearly show an increase in the laser-peened area well indicative of a compressive stress.