Depolarization Calibration and Measurements Using the CANDAC Rayleigh–Mie–Raman Lidar at Eureka, Canada

The Canadian Network for the Detection of Atmospheric Change (CANDAC) Rayleigh–Mie–Raman lidar (CRL) at Eureka, Nunavut, has measured tropospheric clouds, aerosols, and water vapour since 2007. In remote and meteorologically significant locations, such as the Canadian High Arctic, the ability to add new measurement capability to an existing well-tested facility is extremely valuable. In 2010, linear depolarization 532 nm measurement hardware was installed in the lidar's receiver. To minimize disruption in the existing lidar channels and to preserve their existing characterization so far as is possible, the depolarization hardware was placed near the end of the receiver cascade. The upstream optics already in place were not optimized for preserving the polarization of received light. Calibrations and Mueller matrix calculations are used to determine and mitigate the contribution of these upstream optics on the depolarization measurements. The results show that with appropriate calibration, indications of cloud particle phase (ice vs. water) through the use of the depolarization parameter are now possible to a precision of ±0.05 absolute uncertainty ( ≤ 10 % relative uncertainty) within clouds at time and altitude resolutions of 5 min and 37.5 m respectively, with higher precision and higher resolution possible in select cases. The uncertainty is somewhat larger outside of clouds at the same altitude, typically with absolute uncertainty ≤ 0.1. Monitoring changes in Arctic cloud composition, including particle phase, is essential for an improved understanding of the changing climate locally and globally.