On-ground calibration of the Hitomi Hard X-ray Telescopes

We present x-ray characteristics of the Hard X-ray Telescopes (HXTs) on board the Hitomi (ASTRO-H) satellite. Measurements were conducted at the SPring-8 BL20B2 beamline and the ISAS/JAXA 27-m beamline. The angular resolution defined by a half-power diameter was 1.9 ' (HXT-1) and 2.1 ' (HXT-2) at 8 keV, 1.9 ' at 30 keV, and 1.8 ' at 50 keV. The effective area was found to be 620 cm(2) at 8 keV, 178 cm(2) at 30 keV, and 82 cm(2) at 50 keV per mirror module. Although the angular resolutions were slightly worse than the requirement (1.7 '), the effective areas sufficiently exceeded the requirements of 150 cm(2) at 30 keV and 55 cm2 at 50 keV. The off-axis measurements of the effective areas resulted in the field of view being 6.1 ' at 50 keV, 7.7 ' at 30 keV, and 9.7 ' at 8 keV in diameter. We confirmed that the main component of the stray x-ray light was significantly reduced by mounting the precollimator as designed. Detailed analysis of the data revealed that the angular resolution was degraded mainly by figure errors of mirror foils, and the angular resolution is completely explained by the figure errors, positioning errors of the foils, and conical approximation of the foil shape. We found that the effective areas were similar to 80% of the designed values below 40 keV, whereas they steeply decline above 40 keV and become only similar to 50%. We investigated this abrupt decline and found that neither the error of the multilayer design nor the errors of the incident angles induced by the positioning errors of the foils can be the cause. The reflection profile of each foil pair from the defocused image strongly suggests that the figure errors of the foils probably bring about the reduction in the effective areas at higher energies. (c) The Authors. Published by SPIE under a Creative Commons Attribution 3.0 Unported License.