Influence of spatial resolution on population PM 2.5 exposure and health impacts

Health effect estimates depend on the methods of evaluating exposures. Due to non-linearities in the exposure-response relationships, both the predicted mean exposures as well as its spatial variability are significant. The aim of this work is to systematically quantify the impact of the spatial resolution on population-weighted mean concentration (PWC), its variance, and mortality attributable to fine particulate matter (PM 2.5 ) exposure in Finland in 2015. The atmospheric chemical transport model SILAM was used to estimate the ambient air PM 2.5 concentrations at 0.02° longitudinal × 0.01° latitudinal resolution (ca. 1 km), including both the national PM 2.5 emissions and the long-range transport. The decision-support model FRES source-receptor matrices applied at 250-m resolution was used to model the ambient air concentrations of primary fine particulate matter (PPM 2.5 ) from local and regional sources up to 10 km and 20 km distances. Numerical averaging of population and concentrations was used to produce the results for coarser resolutions. Population-weighted PM 2.5 concentration was 11% lower at a resolution of 50 km, compared with the corresponding computations at a resolution of 1 km. However, considering only the national emissions, the influences of spatial averaging were substantially larger. The average population-weighted local PPM 2.5 concentration originated from Finnish sources was 70% lower at a resolution of 50 km, compared with the corresponding result obtained using a resolution of 250 m. The sensitivity to spatial averaging, between the finest 250-m and the coarsest 50-km resolution, was highest for the emissions of PPM 2.5 originated from national vehicular traffic (about 80% decrease) and lowest for the national residential combustion (60% decrease). Exposure estimates in urban areas were more sensitive to the changes of model resolution (14% and 74% decrease for PM 2.5 and local PPM 2.5 , respectively), compared with estimates in rural areas (2% decrease for PM 2.5 and 36% decrease for PPM 2.5 ). We conclude that for the evaluation of the health impacts of air pollution, the resolution of the model computations is an important factor, which can potentially influence the predicted health impacts by tens of percent or more, especially when assessing the impacts of national emissions.