Ultrasonic Nanocrystal Surface Modification of High-Speed Tool Steel (AISI M4) Layered Via Direct Energy Deposition

Tensile residual stress in the laser-deposited M4 fabricated by direct energy deposition (DED) may reduce the fatigue performance and tool life. Ultrasonic nanocrystal surface modification (UNSM) can induce compressive residual stress by generating severe plastic deformation of the material surface, and improve the wear resistance through surface texture refinement. In the present study, we investigated the changes in the metallurgical and mechanical properties of DEDed M4 specimens as induced by UNSM treatment. An X-ray diffraction analysis showed that the DEDed M4 austenite was transformed into martensite after UNSM processing. The change in the full width at half maximum revealed a grain size decrease of 25.8%. Conversion of the tensile residual stress within the DEDed M4 to compressive residual stress through UNSM treatment was confirmed. These changes in the metallurgical characteristics yield a 24.1% increase in the DEDed M4 hardness. A wear test was conducted to evaluate the wear resistances of heat-treated D2, DEDed M4 on D2, and UNSM-DEDed specimens. Ball-on-disk wear tests revealed that the DEDed M4 specimen wear rate was 68.3% lower than that of the H-D2. In addition, the DEDed M4 wear rate was reduced by 85.7% through UNSM treatment. The surface roughness was reduced by up to 88.3%, while micro-dimple shapes were formed on the DED-treated M4 surface. This study has demonstrated that UNSM can be applied to a DED-treated M4 surface to enhance its metallic and mechanical properties.