Influence of the morphology and viscoelasticity on the thermomechanical properties of poly(lactic acid)/thermoplastic polyurethane blends compatibilized with ethylene-ester copolymer

Viscoelastic, interfacial properties, and morphological data were employed to predict the thermal and mechanical properties of compatibilized poly(lactic acid) (PLA)/thermoplastic polyurethane (TPU) blends. The combination of interfacial thickness measured by contact angle and entanglement density determined by dynamical mechanical analysis analyze data was employed to evaluate the mechanical behavior of PLA/TPU blends with and without ethylene-butyl acrylate-glycidyl methacrylate (EBG) compatibilization agent. The PLA/TPU blend (70/30 wt %) was prepared in a Haake internal mixer at 190 degrees C and compatibilized with different contents of EBG. The evaluation of the interfacial properties revealed an increase in the interfacial layer thickness of the PLA/TPU blend with EBG. The scanning electronic microscopy images showed a drastic reduction in the size of the dispersed phase by increasing the compatibilizer agent EBG content in the blend. The compatibilization of the PLA/TPU blends improved both the Izod impact strength and yield stress by 38 and 33%, respectively, in comparison with neat PLA/TPU blend. The addition of EBG into PLA/TPU blends significantly increased the entanglement density and the PLA toughening but resulted in a decrease of PLA deformation at break. The PLA and TPU glass transitions were affected by the EBG, suggesting that the PLA and TPU domains were partially miscible. (C) 2020 Wiley Periodicals, Inc.