Investigating the n=1 and n=2 error fields in W7-X using the newly accelerated FIELDLINES code

No fusion device can be created without some uncertainty; there is always a slight deviation from the geometric specification. These deviations can add up create a deviation of the magnetic field. This deviation is known as the (magnetic) error field. Correcting these error fields is desired as they cause asymmetries in the divertor loads and can thus cause damage to the device if they grow too large. These error fields can be defined by their toroidal (n) and poloidal number (m). The correction of the n = 1 and n = 2 fields in Wendelstein 7-X (W7-X) is investigated in this work. This investigation focuses on field line diffusion to the divertor, a proxy for divertor heat flux. Such work leverages the 25x speedup obtained through the implementation of a new particle-wall collision model. The n = 1 and n = 2 error fields of the as-built coils model of W7-X are corrected by scanning phase and amplitude of the trim and control coils. Reductions in the divertor load asymmetry by factors of four are demonstrated using error field correction. It is found that the as-built coils model has a significantly lower m/n = 1/1 error field than found in experiments (Bozhenkov et al 2018 Nucl. Fusion 59 026004).