Poly(vinyl alcohol) nanofibrous membranes via green electrospinning and tannin coating for selective removal of Pb(II) ion

The conventional adsorbent fabrication methods involve complicated processes and may cause secondary contaminations. Therefore, an effective eco-friendly method is required for the fabrication of heavy metal adsorbents using inexpensive and eco-friendly materials without secondary pollution during their process. In this study, nanofibrous membranes (NFMs) were fabricated via green electrospinning of poly(vinyl alcohol) (PVA), a hydrophilic polymer, and their water resistance was improved through simple heat treatment without using additional additives. Then, nanofibrous heavy metal adsorbents were prepared by dip-coating the NFMs in an aqueous solution of tannic acid (TA), a natural polyphenol. First, the adsorption/desorption behavior of TA on PVA NFMs during the TA coating process was investigated. In addition, the effects of TA coating on the mechanical properties and heavy metal adsorption characteristics of the PVA NFMs were analyzed. The TA coating significantly increased the mechanical strength, heat resistance, and heavy metal (Pb(II)) adsorption capacity of the PVA NFM. The Pb2+ adsorption amount of TA-coated PVA NFMs exhibited about 5–7 times higher than those of other heavy metal ions, indicating excellent selectivity for Pb2+. In addition, the TA-coated PVA NFMs retained >70% of its initial adsorption capacity even after four cycles of adsorption/desorption, indicating its reusability.