Improved Charge Density and Stability in PDMS Ferroelectrets Using PDMS/PTFE Composite Materials

A ferroelectret is a flexible cellular polymer structure that generates electrical power under mechanical force. It behaves like a piezoelectric material in that a voltage is generated when the ferroelectret deforms. Its electrical output significantly depends on the surface charge density of the material used. Previous ferroelectrets fabricated from polydimethylsiloxane (PDMS) benefit from the soft, stretchable mechanical properties of the PDMS but the ability of this material to trap charge at its surface is poor. This paper presents approaches to enhance the surface charge density and stability of a PDMS based ferroelectret device by adding Polytetrafluoroethylene (PTFE) to the PDMS. This PDMS/PTFE composite has been evaluated when used to fabricate the ferroelectret device and when used as an additional coating the internal void surfaces of an otherwise plain PDMS ferroelectret. As the proportion of PTFE increases, the surface charge density on the void surfaces increases resulting in a corresponding increase in the piezoelectric properties of the ferroelectret. A weight ratio of PTFE powder and PDMS of 1:3 was found to achieve improved piezoelectric performance with an initial effective piezoelectric coefficient, d33e, of around 700 pC/N which decayed initially and reached a steady state value of around 365 pC/N measured after 4 months after poling. This presents a considerable improvement in performance when compared with the effective d33e of pure PDMS which has an initial value of around 110 pC/N and drops to below 8 pC/N after 4 months. The energy harvester potential of the ferroelectret was explored by cyclically compressing the PDMS/ PTFE composite layer ferroelectret structure with a force of 500 N applied at 1 Hz. The output of the ferroelectret was found to charge a 10 mu F capacitor to 0.12 V after 40 s. Maximum output power occurs at a load resistance of 15 M omega, with a peak power of 4 mu W. A fabricated PDMS/PTFE composite layer ferroelectret sample (weight ratio of PTFE powder and PDMS of 1:3) was also tested as a pressure sensor range from 0 to 500 N and achieved a sensitivity of 9.9 mV/N. The nonlinearity error of the proposed sensor was 1.7%.