Non-Linearity of Thermosetting Polymers' and GRPs' Thermal Expanding: Experimental Study and Modeling

Thermal expanding is the important property that defines the stress-strain condition of GRP structures exploited under heating and having limited thermal resistance. So, the GRPs' thermal expanding prediction is the actual requirement of such structures design. The experimental accurate dilatometric study resulted in the non-linearity of thermosetting polymers and plastics thermal expanding under heating. The polymers and plastics thermal expanding coefficient (CTE) is non-linearly increasing under heating before glassing temperature (Tg). Using the previous polymers and GRPs modelling experience and experimental dilatometric results, the non-linear adequate prediction models of their CTE were proposed and proved. The new compensative wave model of polymers' CTE and multi-layer model of GRPs' CTE were proposed and successfully tested. A prediction of the temperature dependences of the thermal expansion coefficients of various thermoset polymer binders and data on the reinforcement structure was performed based on the experimentally obtained temperature dependences of the CTEs of GRPs. The prediction was performed using the finite-element homogenization method in the Material Designer module of the academic version of the Ansys package. A satisfactory concurrence of the numerical results of the prognosis and the experiment for all considered cases is observed in the temperature range from 50 to 100 degrees C, after glass transition temperature best coincidence of numerical values of CTE is obtained for glass-reinforced plastics on epoxy resin, which were not subjected to thermal aging.