The influence of thermochemistry on the reactivity of propane, the pentane isomers and n -heptane in the low temperature regime

The influence of thermochemistry on the reactivity of fuels at low temperatures (600-1000 K) is studied here. Specifically, the effect of different sets of thermochemistry on chemical model predictions is explored, where various sets are calculated at different levels of theory in addition to recently updated group addi-tivity values. Experimentally measured ignition delay times for propane, the pentane isomers and n-heptane are simulated using NUIGMech1.2 and replacing the thermochemistry of the low-temperature species with the calculated values. For propane, three different thermochemistry sets were calculated, namely CCSD(T)-F12/TZ-F12//B2PLYP-D3/TZ//B2PLYP-D3/TZ (QM1), CCSD(T)-F12/TZ-F12//B2PLYP-D3/TZ//& omega;B97X-D/TZ (QM2) and B2PLYP-D3/TZ/& omega;B97X-D/6-31G *//& omega;B97X-D/6-31G* (QM3). The QM2 results provide parameters to optimize new group additivity (NGA) values which are used to calculate the fourth set of ther-mochemistry. The model predictions using these four sets are compared to those using NUIGMech1.2 for propane. As the QM1 and QM2 calculations are expensive, the thermochemistry calculated from the QM3 and NGA calculations are used in the pentane isomer and n-heptane models. For all of the models, it is found that the thermochemistry of the species involved in the low-temperature reaction sequence (RH, R, RO2H, R O2, Q OOH and O2QOOH species) significantly affect fuel reactivity. The NGA values were developed based on all of these species except O2QOOH radicals. The thermochemistry of O2QOOH species cannot be accurately calculated with the NGA representations due to the importance of non-next-nearest neighbor interactions of -OOH substitution. Further development of the NGA method to capture such interactions is in progress. Overall, the model developed using the NGA thermochemistry shows better agreement with experimental data than the model using thermochemistry from affordable and prominent QM methods, such as QM3. Based on the results presented for propane, the pentane isomers and n-heptane, the thermochem-istry calculated using the NGA method can be used to model the oxidation of higher order hydrocarbons at low temperatures.& COPY; 2022 The Combustion Institute. Published by Elsevier Inc. All rights reserved.