Study of combined heat and power plant integration with thermal energy storage for operational flexibility

Increasing the share of renewable energy in the future electricity market requires measures to maintain the stability of the grid, owing to the volatility and intermittency of renewable energy. For a combined heat and power (CHP) plant, molten salt thermal energy storage (TES) can be added to improve the flexibility to meet the needs of peak shaving. This paper proposed a novel cascade reheat steam extraction system to adjust the elec-trical load by using EBSILON software applied to thermal simulation and thermal analysis. A 350 MW super-critical CHP plant was used as an example to analyze the thermal and peak shaving performance under variable operating conditions. Meanwhile, through the static simulation, the change in the load and the efficiency of TES can be calculated during the charging and discharging cycle. The results show that the efficiency of TES is 40-51 %. With an increase in the load, the efficiency of TES is reduced, and the exergy loss range is from 4 MW to 12.4 MW mainly due to the throttling process and the molten salt heat transfer process. Moreover, the thermal ef-ficiency and exergy efficiency of the novel system are higher than those of the traditional CHP plant below 60 % turbine heat acceptance, so it is relatively economical to run for peak shaving under low loads. Finally, depending on the corresponding operating strategy, a reduction of the minimum load by up to 1 % of the rated output electrical load during charging and an increase of the maximum load by up to 2 % of the rated output electrical load during discharging are possible. Overall, the proposed system provides a feasible method for the flexibilization of CHP plants alongside new renewable systems.