Transducer-Aware Hydroxy-Rich-Surface Indium Oxide Gas Sensor for Low-Power and High-Sensitivity NO2 Gas Sensing

Low-power metal oxide (MOX)-based gas sensors are widely applied in edge devices. To reduce power consumption, nanostructured MOX-based sensors that detect gas at low temperatures have been reported. However, the fabrication process of these sensors is difficult for mass production, and these sensors are lack uniformity and reliability. On the other hand, MOX film-based gas sensors have been commercialized but operate at high temperatures and exhibit low sensitivity. Herein, commercially advantageous highly sensitive, film-based indium oxide sensors operating at low temperatures are reported. Ar and O2 gases are simultaneously injected during the sputtering process to form a hydroxy-rich-surface In2O3 film. Conventional indium oxide (In2O3) films (A0) and hydroxy-rich indium oxide films (A1) are compared using several analytical techniques. A1 exhibits a work function of 4.92 eV, larger than that of A0 (4.42 eV). A1 exhibits a Debye length 3.7 times longer than that of A0. A1 is advantageous for gas sensing when using field effect transistors (FETs) and resistors as transducers. Because of the hydroxy groups present on the surface of A1, A1 can react with NO2 gas at a lower temperature (similar to 100 degrees C) than A0 (180 degrees C). Operando diffuse reflectance infrared Fourier transform spectrometry (DRIFTS) shows that NO2 gas is adsorbed to A1 as nitrite (NO2-) at 100 degrees C and nitrite and nitrate (NO3-) at 200 degrees C. After NO2 is adsorbed as nitrate, the sensitivity of the A1 sensor decreases and its low-temperature operability is compromised. On the other hand, when NO2 is adsorbed only as nitrite, the performance of the sensor is maintained. The reliable hydroxy-rich FET-type gas sensor shows the best performance compared to that of the existing film-based NO2 gas sensors, with a 2460% response to 500 ppb NO2 gas at a power consumption of 1.03 mW.