Aluminum Oyster Mushroom Frying Surface Quality Improvement Through Anodizing
Key Engineering Materials(2022)
Abstract
Aluminum is the most often used metal in modern industry and has a long history of use. This material has several advantages and downsides. Among the drawbacks are some aluminum alloys that cannot survive the corrosion rate produced by the environment. To address these problems, numerous procedures are used, one of which being anodizing. The goal of this procedure is to oxidize the metal surface, forming a coating of aluminum oxide that will protect it from the damaging impacts of the environment. As a result, the coating method is used. Stearic acid and lauric acid were employed in the coating procedure in this investigation. Stearic acid and lauric acid were employed in the coating procedure in this investigation. By performing the anodizing process first, then the coating process, the hydrophobicity properties of the many variations employed may be determined by examining the contact angle generated by the droplet outcomes. Untreated sample with a contact angle of 65° were found to have hydrophilic qualities, while the anodizing treatment had a contact angle close to 0°, and the anodizing process with stearic acid and lauric acid coating had contact angles of 117° and 130°, respectively. A sliding angle was also achieved for each treatment applied to the test sample, with the anodizing process obtaining a sliding angle of 59°, the anodizing process with stearic acid coating obtaining a sliding angle of 38°, and the coating with lauric acid obtaining a sliding angle of 28°. The coating utilizing stearic acid and lauric acid has strong hydrophobicity due to its superhydrophobic nature, which may resist the entry of water on the aluminum basis, according to the various treatments performed.
MoreTranslated text
求助PDF
上传PDF
View via Publisher
AI Read Science
AI Summary
AI Summary is the key point extracted automatically understanding the full text of the paper, including the background, methods, results, conclusions, icons and other key content, so that you can get the outline of the paper at a glance.
Example
Background
Key content
Introduction
Methods
Results
Related work
Fund
Key content
- Pretraining has recently greatly promoted the development of natural language processing (NLP)
- We show that M6 outperforms the baselines in multimodal downstream tasks, and the large M6 with 10 parameters can reach a better performance
- We propose a method called M6 that is able to process information of multiple modalities and perform both single-modal and cross-modal understanding and generation
- The model is scaled to large model with 10 billion parameters with sophisticated deployment, and the 10 -parameter M6-large is the largest pretrained model in Chinese
- Experimental results show that our proposed M6 outperforms the baseline in a number of downstream tasks concerning both single modality and multiple modalities We will continue the pretraining of extremely large models by increasing data to explore the limit of its performance
Upload PDF to Generate Summary
Must-Reading Tree
Example

Generate MRT to find the research sequence of this paper
Related Papers
2016
被引用100 | 浏览
2019
被引用68 | 浏览
2018
被引用31 | 浏览
2021
被引用17 | 浏览
2021
被引用28 | 浏览
2022
被引用18 | 浏览
Data Disclaimer
The page data are from open Internet sources, cooperative publishers and automatic analysis results through AI technology. We do not make any commitments and guarantees for the validity, accuracy, correctness, reliability, completeness and timeliness of the page data. If you have any questions, please contact us by email: report@aminer.cn
Chat Paper
GPU is busy, summary generation fails
Rerequest