Nanoscale microstructures and hydrogenation properties of an as-cast vanadium-based medium-entropy alloy

Vanadium-based hydrogen storage alloys have been widely investigated; however, alloys in the cast state are typically coarse-grained. In this study, an as-cast V45Fe15Ti20Cr20 mediumentropy alloy was prepared by arc melting, and microstructural analysis revealed that the alloy was composed of nanocrystals. The initial pretreatment temperature of the alloy was approximately 100 K lower than that of the as-cast coarse-grained alloy. At room temperature, the time required for the alloy to reach 90% saturation was only 140 s, indicating excellent hydrogen absorption kinetics. The alloy is fully activated after two hydrogen absorption/desorption cycles. The phase transformation of the alloy in the early hydrogenation stage was investigated using X-ray diffraction, and the results showed that the BCC phase was completely transformed into the BCT phase when hydrogen uptake was performed for 6 s. Furthermore, the apparent activation energy of dehydrogenation in the present alloy calculated using the Kissinger method was 69.8 +/- 0.8 kJ/mol. The pressure-compositionisotherms tests showed that the hydrogen absorption capacity of the alloy at 295 K was 2.12 wt%. The hydrogenation/dehydrogenation enthalpy change of the alloy was calculated by the Van't Hoff equation, which was 30.90 +/- 1.47 and 33.95 +/- 0.41 kJ/mol, respectively. The present work demonstrates that nanostructured vanadium-based hydrogen storage alloys can be fabricated using traditional casting techniques. Our study also enriches the understanding of the microstructures of medium-entropy alloys, which may provide positive guidance for the design of novel vanadium-based hydrogen storage alloys. (c) 2023 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.