Fracture toughness of AlSi10Mg alloy produced by direct energy deposition with different crack plane orientations

The fracture and tensile behaviors of the AlSi10Mg alloy processed by Direct Energy Deposition were investi-gated. Three-point bending fracture toughness and tensile specimens were tested at room temperature along different crack plane orientations and loading directions. Before being machined and tested, the printed samples were subjected to heat treatment at 300 degrees C for 2 h to relieve the residual stresses. Microstructural and fracto-graphic analyses were performed to investigate the fracture mechanisms and the crack propagation paths for each crack orientation. Significant differences in the fracture toughness were observed among the crack plane orientations. Specimens with cracks oriented in the X-Y direction featured the highest fracture toughness values (JIc = 11.96 kJ/m2), whereas the Z-Y crack orientation (perpendicular to the printing direction) performed the lowest fracture toughness values (JIc = 8.91 kJ/m2). The anisotropy in fracture toughness is mainly related to a preferential crack propagation path along the melt pool boundaries. At melt pool boundaries, pores are pref-erentially placed, coarsening of the microstructure occurs and there is higher Si content, leading to that area being less ductile and less resistant to crack propagation.