Investigating the Effects of Defects and the Effect of Geometric Anisotropy in Stainless Steel Pipes: Phased Array Ultrasonic Test, SH-wave

Today, Phased Array Ultrasonic Testing (PAUT) is a suitable method for detecting defects in Non-destructive Testing (NDT). This simulation was done with a new method on a stainless steel pipe with a diameter of 500 mm and a length of 1,000 mm, and cracks were modeled on the external and internal surfaces and corrosion defects on the internal surface. Four probes with a characteristic of 2 MHz were used simultaneously, each probe having 64 elements. By increasing the number of probes and their elements, more accurate information about the defects is obtained, which makes it easier to detect the location and leads to a reduction of scattered signals and noise, which can detect even small size defects. Considering this important advantage, a new use of the method of increasing the number of probes in PAUT is reported in this study to detect defects, especially corrosion defects. The results of geometric anisotropy studies of group velocity and phase of horizontally polarized shear waves (SH-waves) for stainless steel pipe were presented. Due to the isotropic properties of the pipe material, the speed on the outer surface of the pipe in the direction of the cover is 40 m/s higher than the generatrix.