Effect of shear strain on the electronic and optical properties of Al-doped stanane

Context The quasi-metallic properties of stanene limit its prospects in optoelectronic devices. Based on first-principles calculations, a systematic study is conducted on the tuning effects of surface hydrogenation and Al atom doping on the electronic and optical properties of stanene. Surface hydrogenation serves as an ideal way to open the forbidden band of stanene, and Al atom doping further increases hydrogenated stanene (stanane) band gap to 0.460 eV. Deformation has a minor impact on the stability of the stanane-Al structure, while shear strain can effectively modulate the band gap engineering of the doped system, reducing the band gap value from 0.460 to 0.170 eV. Deformation induces a redshift in the absorption peak and reflectance, also slowing down the rate of decrease in the absorption coefficient, and enhancing the peak value of light reflectance, which is positively correlated with the degree of shear strain. These findings hold promise for expanding the potential application of monolayer stanane in semiconductor devices. Methods All calculations are performed using CASTEP module in Materials Studio based on the density functional theory (DFT). The Perdew–Burke–Ernzerhof (PBE) generalized gradient approximation (GGA) is employed to describe the exchange–correlation energy (Perdew et al., Phys Rev Lett 77(18), 1996). We construct models for both stanene and stanane. The original unit cell of stanene has two Sn atoms, while stanane consists of two Sn atoms and two H atoms, and expand them to a 3 × 3 × 1 supercell with a vacuum layer of 20 Å in height to prevent interlayer coupling. After convergence testing, the plane-wave cutoff energy is set to 450 eV, and the energy convergence threshold is set to 1 × 10 −5 eV. The maximum residual stress for each atom is set to 0.01 eV/Å. Brillouin zone sampling is performed using a 6 × 6 × 1 k-point mesh based on the Monkhorst–Pack method (Monkhorst and Pack, Phys Rev B 13(12), 1976). The k-point accuracy of the density of states and optical properties is 9 × 9 × 1. All calculations are performed using the more advanced OTFG ultrasoft pseudopotential, and structural relaxations are performed using supercells to ensure that the model is fully relaxed. We use the HSE06 functional to calculate the energy band structures of stanane-Al deformed to 0%, 4%, and 8%, resulting in band gap values of 1.465 eV, 1.368 eV, and 1.016 eV, respectively. These values are significantly higher than those obtained using the PBE functional (0.460 eV, 0.397 eV, and 0.170 eV). However, the shapes and trends of the band structures obtained from both PBE and HSE06 calculations are similar. Additionally, the calculation time needed by HSE06 is greatly longer than PBE, which exceeds the capabilities of our computer hardware, and cannot support all subsequent calculations. To investigate the influence of deformations on the variation of band gap values and to conserve computational resources, the subsequent calculations in this study use the PBE functional.