Poly(-caprolactone) and Eudragit E blends modulate the drug release profiles from FDM printlets

Thermoplastic polymers have been used to produce filaments by hot melt extrusion (HME), which can be applied to obtain 3D printlets by fused deposition modelling (FDM). Poly(epsilon-caprolactone) (PCL) is a low melting point thermoplastic polymer that provides HME filaments with excellent mechanical and printability properties. However, due to the highly hydrophobic properties of PCL, they afford printlets with slow drug release behaviour. We hypothesized that blending a less hydrophobic polymer, the Eudragit E (EudE), with PCL could be an approach to increase the drug release rate from PCL 3D printlets. PCL and EudE were blended at different proportions, 50:50, 60:40, 70:30, and 80:20 (w/w), to produce HME filaments. They were produced with dexamethasone at 5 % (w/w) and were effectively extruded and printable by FDM, except that composed of 50:50 (w/w). Printlets had homogeneous distribution of their components. Their drug release behaviour was dependent on the ratio of the polymeric blends. The highest EudE ratio (60:40 w/w) afforded printlets showing the highest release rate. Therefore, adding up to 40 % (w/w) of EudE to PCL does not impair the mechanical and printability properties of its HME filaments. This innovative approach is proposed here to modulate the drug release behaviour from PCL printlets.