Enhancement of the Thermoelectric Performance of Half-Metallic Full-Heusler Mn2VAl Alloys Via Antisite Defect Engineering and Si Partial Substitution

A half-metallic full-Heusler Mn2VAl alloy is a potential p-type thermoelectric material that can directly generate electricity from waste heat via the Seebeck effect. For practical use, the Seebeck coefficient S of Mn2VAl should be increased while maintaining a high electrical conductivity a from its half-metallic character. Herein, we achieved this objective through antisite defect engineering. Theoretically, it was predicted that the S was maximized by regulating partial density of states of majority-spin sp-electrons through the control of the fraction of antisite defect, fAD, between V and Al atoms in Mn2VAl. Experimentally, a significant increase in S and a slight decrease in a were observed for an Mn2VAl sample with an optimal fAD = 33%, enhancing the thermoelectric power factor PF by 2.7 times from an Mn2VAl sample with fAD = 14%. Furthermore, we combined the antisite defect engineering with a partial substitution method. An Mn2V(Al0.96Si0.04) sample with fAD = 33% exhibited the highest PF = 4.5 x 10-4 W center dot m-1 center dot K-2 at 767 K among the samples. The maximum dimensionless figure-of-merit zT of the Mn2V(Al0.96Si0.04) sample with fAD = 33% was measured to be 3.4 x 10-2 at 767 K, which is the highest among the p-type half-metallic full-Heusler alloys. (c) 2023 The Authors. Published by Elsevier B.V. on behalf of The Chinese Ceramic Society. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).