Simultaneous Water Sorption and Crystallization in ASDs 1: Stability Studies Lasting for Two Years

One way to increase the slow dissolution rate and the associated low bioavailability of newly developed active pharmaceutical ingredients (APIs) is to dissolve the API in a polymer, leading to a so-called amorphous solid dispersion (ASD). However, APIs are often supersaturated in ASDs and thus tend to crystallize during storage. The kinetics of the crystallization process is determined by the amount of water the ASD absorbs during storage at relative humidity (RH), storage temperature, polymer type, and the drug load of the ASD. Here, the crystallization kinetics and shelf life of spray-dried ASDs were investigated for ASDs consisting of nifedipine (NIF) or celecoxib (CCX) as the APIs and of poly-(vinylpyrrolidone-co-vinyl acetate) or hydroxypropyl methylcellulose acetate succinate as polymers. Samples were stored over 2 years at different RHs covering conditions above and below the glass transition of the wet ASDs. Crystallization kinetics and onset time of the crystallization were qualitatively studied by using powder X-ray diffraction and microscopic inspection and were quantitatively determined by using differential scanning calorimetry. It was found that the NIF ASDs crystallize much faster than CCX ASDs at the same drug load and at the same storage conditions due to both higher supersaturation and higher molecular mobility in the NIF ASDs. Experimental data on crystallization kinetics were correlated using the Johnson-Mehl-Avrami-Kolmogorov equation. A detailed thermodynamic and kinetic modeling will be performed in Part 2 of this paper series.