Ethane-CO₂ Mixture Adsorption in Silicalite: Influence of Tortuosity and Connectivity of Pores on Selectivity

Selective adsorption using nanoporous materials is an efficient strategy for separating gas mixtures. In a nanoporous material, pores can exist in different shapes and can have different degrees of inter-connectivity. In recent studies, both pore connectivity and tortuosity have been found to affect the adsorption and dynamical properties of ethane and CO2 in silicalite differently. Here, using Monte Carlo simulations, we investigate if these two attributes can affect the selective adsorption of one component from a mixture of ethane and CO2 in silicalite. For this, the adsorption of an equimolar mixture of ethane and CO2 is simulated in 12 models of silicalite-SnZm (n, m = 0, 1, 2, 3 or 4; with n and m denoting, respectively, the fraction (out of 4) of straight and zigzag channels of silicalite that are available for adsorption)-differing in degrees of pore connectivity and tortuosity. The adsorption selectivity in this system is found to exhibit a reversal with the adsorption dominated by ethane at low pressures (below similar to 1 atm) and by CO2 at higher pressures (above similar to 10 atm). Pore connectivity is found to suppress the selective adsorption of CO2 at higher pressures and also shifts the selectivity reversal to higher pressures. The selectivity reversal results from a competition between the polarizability-affected adsorption at lower pressures and efficient packing at higher pressures. The efficient packing of CO2 is a compounded effect resulting from the larger effective pore volume available for CO2 due to its stronger interaction with the pore surface and smaller molecular volume. CO2 molecules show a preference to adsorb in non-tortuous pores, and this preference is found to be stronger in the presence of ethane. The effects of pore connectivity and tortuosity elucidated here should be applicable to a wide range of natural and engineered nanoporous materials, and this knowledge could be used to identify materials with better capability for separating and storing CO2 based on their pore attributes.