Combustion performance modulation and agglomeration inhibition of HTPB propellants by fine Al/oxidizers integration

Modulation of burning rates and inhibition of aluminum agglomeration in solid propellants have generated considerable research interest in the field of energetic materials. In this paper, integrated Al/oxidizer composites have been prepared by a spray-drying technique, which offer intimate contact between the fuel and oxidizers. The morphologies, thermal stability, density, heats of explosion and combustion performance of the resulted solid propellants containing these Al-based composites were systematically investigated, where the condensed combustion products (CCPs) analysis and the agglomeration behavior of Al particles have been focused. After well control of the Al/oxidizers structure, 9 % higher explosion heat, 58 % higher pressurization rate and 65 % stronger flame radiation intensity were achieved in comparison to the conventional solid propellants with the same formulation. The burn rate of the propellants can also be well controlled by using different type of Al/oxidizers composites, in the range of 3.6–5.9 mm s−1 under 0.5 MPa and 9.2–10.9 mm s−1 under 15 MPa. More importantly, very low burn rate pressure exponent of 0.1 within 0.5–15 MPa was obtained. Inspired by decreasing size of CCPs, the evolution of Al on the burning surface was studied and the agglomeration inhibition was observed, whose potential mechanism was then proposed and elucidated.