Monolithic design of self-adaptive CMOS converter and robust event-triggered consensus control for integration of multi-renewable energy sources with battery storage system

Recently, integrating renewable energy sources (RESs) has been one of the most effective ways to overcome the power shortage problems due to the cumulative load demand, which cannot be covered using conventional power production. DC-DC converters with a wide voltage conversion range are highly important when integrating RESs to achieve voltage matching. In recent years, many large-scale improvements have been made to the DC-DC converters to improve reliability, effectiveness, flexibility, modularity, and cost-effectiveness. This study investigates the feasibility of integrating RESs and designing the most effective structure using complementary metal-oxide semiconductors (CMOS) for DC-DC converters. A novel monolithic CMOS buck converter with an adaptive sensing feedback system (ASFS) circuit is proposed for renewable integrated systems. The proposed converter based on ASFS provides a wide range of conversion voltages, low cost, and reliability. It depends on the pulse-width modulation (PWM) technique with a voltage-control duty-cycle (VCDC) circuit. The proposed multi-input DC-DC converter is tested to integrate three RESs to form an integrated hybrid system. The proposed converter is built to integrate the PV, wind turbine (WT), wave energy source, and battery energy storage system (BESS). The proposed DC-DC converter is tested to adjust the output voltage of the RESs at 12 V with a load current of 2.4 A to facilitate the integration process. The results show the success of the proposed converter in maintaining the output voltage at 12 V, with maximum efficiency of the CMOS buck DC-DC converter reaching 96.25 % over a wide input voltage range from 15 V to 35 V. Moreover, the maximum peak-peak ripple over the output voltage reaches 600 mV at the maximum input voltage of 35 V. A control method-based event-triggered consensus algorithm has been proposed to regulate the system voltage and ensure active power sharing in the microgrid system. The controller's settling time and rise time have been measured, and a robustness analysis has been performed based on the connections and disconnections of DGs and the impact of faults.